Variability and Yield in h‐BN‐Based Memristive Circuits: The Role of Each Type of Defect. Issue 41 (4th September 2021)

• Record Type: Journal Article
• Authors: Shen, Yaqing; Zheng, Wenwen; Zhu, Kaichen; Xiao, Yiping; Wen, Chao; Liu, Yingwen; Jing, Xu; Lanza, Mario
• Is Part Of: Advanced materials. Volume 33:Issue 41(2021)
• Page Start: n/a
• Page End: n/a
• Publication Date: 2021-09-04
• Subjects: 2D materials -- local defect -- memristors -- wrinkles of 2D layered materials; Materials -- Periodicals; Chemical vapor deposition -- Periodicals; 620.11
• DOI: 10.1002/adma.202103656
• Languages: English
• ISSNs: 0935-9648

Abstract

Abstract: In the race of fabricating solid‐state nano/microelectronic devices using 2D layered materials (LMs), achieving high yield and low device‐to‐device variability are the two main challenges. Electronic devices that drive currents in‐plane and homogeneously along the 2D‐LMs (i.e., transistors, memtransistors) are strongly affected by local defects (i.e., grain boundaries, wrinkles, thickness fluctuations, polymer residues), as they create inhomogeneities and increase the device‐to‐device variability, resulting in a poor performance at the circuit level. Here, it is shown that memristors are insensitive to most types of defects in 2D‐LMs, even when fabricated in academic laboratories that do not meet industrial standards. The reason is that the currents produced in these devices, which flow out‐of‐plane across the 2D‐LM, are always driven locally by the most conductive locations. Consequently, it is concluded that it is much easier to fabricate 2D‐LMs‐based solid‐state nano/microelectronic circuits using memristors than using transistors or memtransistors, not only due to the inherent simpler fabrication process (i.e., less lithography steps) but also because the local defects do not degrade the yield and variability of memristors considerably. Abstract : Large (up to 10 kbit) crossbar arrays of nano‐memristors (down to 320 nm × 420 nm) using hexagonal boron nitride (h‐BN) are fabricated, and their yield and variability are studied. The atomic defects in h‐BN lead to deviations of the electrical characteristics of the devices, while wrinkles, polymer residues, thicker islands, and gaps with the substrate have no remarkable effect.