Overview over the neutral gas pressures in Wendelstein 7-X during divertor operation under boronized wall conditions. (1st May 2023)

• Record Type: Journal Article
• Authors: Haak, V; Bozhenkov, S A; Feng, Y; Kharwandikar, A; Kremeyer, T; Naujoks, D; Perseo, V; Schlisio, G; Wenzel, U
• Is Part Of: Plasma physics and controlled fusion. Volume 65:Number 5(2023)
• Publication Date: 2023-05-01
• Subjects: Wendelstein 7-X -- neutral gas pressure -- particle exhaust; Plasma (Ionized gases) -- Periodicals; Controlled fusion -- Periodicals; 530.44
• DOI: 10.1088/1361-6587/acc8fb
• Languages: English
• ISSNs: 0741-3335

Abstract

Abstract: During the first test divertor campaign of the stellarator experiment Wendelstein 7-X (Pedersen et al 2022 Nucl. Fusion 62 042022), OP1.2b, 13 neutral gas pressure gauges collected data in different locations in the plasma vessel, enabling a detailed analysis of the neutral gas pressures, the compression ratios and the particle exhaust rates via the turbomolecular pumps in the different magnetic field configurations. In Wendelstein 7-X, the edge magnetic islands are intersected by the divertor target plates and used to create a plasma-wall interface. As the number and position of the magnetic islands varies in different magnetic field configurations, the position of the strike line on the target plates and thus the neutral gas pressure in the subdivertor differs between the configurations. Neutral gas pressures on the order of few 10 −4 mbar were measured in the subdivertor region. The highest neutral gas pressure of 1.75 × 10 − 3 mbar was obtained in the so-called high iota configuration featuring four edge magnetic islands per cross section. The neutral particle flux through the pumping gaps into the subdivertor volume was provided by EMC3-EIRENE simulations and allowed to analyze the relation between the particle flux entering the subdivertor and the pressure distribution in the subdivertor. Finite element simulations in ANSYS provide a detailed picture of the pressure distribution in the subdivertor volume and agree with the neutral gas pressure measurements in the subdivertor in the standard configuration featuring an island chain of 5 edge magnetic islands. Surprisingly high neutral gas pressures that were not predicted by the simulation were measured in the subdivertor region away from the main strike line for discharges in the most used magnetic configuration, the standard configuration. While the pressure ratio between the two sections of the subdivertor volume, the low and high iota section is 0.06 in high iota configuration, a ratio of 2–5 was obtained in the other configurations, indicating significant particle loads and exhaust rates on the high iota section of the subdivertor in magnetic configurations with the main strike line on the low iota divertor targets.