Influence of hydrogen on dwell-fatigue response of near-alpha titanium alloys. (15th April 2020)

• Record Type: Journal Article
• Authors: Sinha, V.; Schwarz, R.B.; Mills, M.J.; Williams, J.C.
• Is Part Of: Acta materialia. Volume 188(2020)
• Page Start: 315
• Page End: 327
• Publication Date: 2020-04-15
• Subjects: Titanium alloys -- Hydrogen -- Dwell-fatigue -- Fracture mechanisms -- Facets; Materials -- Periodicals; Materials science -- Periodicals; Materials -- Mechanical properties -- Periodicals; Metallurgy -- Periodicals; Chemistry, Inorganic -- Periodicals; 620.112
• DOI: 10.1016/j.actamat.2019.12.025
• Languages: English
• ISSNs: 1359-6454

Abstract

Abstract: The prior studies have investigated the influence of internal hydrogen on dwell-fatigue behavior of near- α titanium alloys primarily in the lamellar microstructural condition. In the current study, the effects of internal hydrogen, in the range 10–230 ppm (by weight), on the dwell-fatigue behavior of Ti-6242Si alloy were investigated. The examined alloy had a bimodal microstructure comprising approximately 70 vol% primary α grains and 30 vol% transformed β regions. The dwell-fatigue life generally increased with increasing hydrogen content. The dwell-fatigue lives were longer by a factor of as high as 6 for high (≥150 ppm) hydrogen contents than for the low (<60 ppm) hydrogen contents, which is reported for a near- α titanium alloy for the first time. The crack-initiation site was essentially faceted for all the hydrogen levels examined in current study. The crystallographic orientations of fracture facets at the crack-initiation sites were similar for the low (<60 ppm) and high (>150 ppm) hydrogen contents. Specifically, these facets were inclined at ∼8 – 17° from the basal plane. Therefore, the longer dwell-fatigue lives observed for the alloys with hydrogen contents ≥150 ppm could not be explained on the basis of any differences in crystallography of the facets at crack-initiation sites. The longer dwell-fatigue lives for higher hydrogen contents can be explained within the framework of time-dependent load shedding from the soft microtextured regions (MTRs) to the hard MTRs if the local stress redistribution at the soft MTR/hard MTR boundary due to the hold at maximum load is reduced with increasing hydrogen content. Graphical abstract: Image, graphical abstract