Improving the routine analysis of siderite for δ13C and δ18O in environmental change research. (16th January 2023)

• Record Type: Journal Article
• Authors: Lacey, Jack H.; Sloane, Hilary J.; Leng, Melanie J.; Crowley, Stephen F.
• Is Part Of: Rapid communications in mass spectrometry. Volume 37:Number 6(2023)
• Page Start: n/a
• Page End: n/a
• Publication Date: 2023-01-16
• Subjects: Mass spectrometry -- Periodicals; 543.65
• DOI: 10.1002/rcm.9456
• Languages: English
• ISSNs: 0951-4198

Abstract

Abstract : Rationale: The carbon (δ 13 C) and oxygen (δ 18 O) isotope composition of siderite (FeCO3 ) is used widely to understand and quantify geochemical processes to reconstruct past climate and environmental change. However, few laboratories follow precisely the same protocol for the preparation and analysis of siderite‐bearing materials, which combined with the absence of international reference materials and mineral‐specific acid fractionation factors, leads potentially to significant differences in isotope data generated by individual laboratories. Here we examine procedures for the isotope analysis of siderite and discuss factors potentially contributing to inconsistencies in sample measurement data. Methods: Isotope analysis of siderite is first assessed using similar versions of the classical off‐line, sealed vessel acid digestion method by comparing data sets obtained from intercomparison materials measured at two participating laboratories. We then compare data from the classical method against those generated using an automated preparation technique using data produced from an independent set of test materials. Results: Measurement of siderite δ 13 C is generally both repeatable and reproducible, but measurement of δ 18 O may be subject to large (~1‰), method‐dependent bias for siderite reacted at differing temperatures (70°C and 100°C) under classical and automated CO2 preparation conditions. The potential for poor oxygen isotope measurement reproducibility is amplified by local differences in sample preparation protocols and procedures used to calibrate measurement data to international reference scales. Conclusions: We offer suggestions for improving the repeatability and reproducibility of δ 13 C and δ 18 O analysis on siderite. The challenge of producing consistent isotope data from siderite can only be resolved by ensuring the availability of siderite reference materials to facilitate identical treatment as a basis for minimising method‐dependent contributions to data inconsistency between laboratories.