Location Technique based on Multiple Partial Discharge Signal in 11kV Underground Power Cable using EMTP-ATP Software. Issue 1 (February 2021)

• Record Type: Journal Article
• Authors: Halim, M I A M; Rohani, N K H; Rosle, N; Rosmi, A S C; Yii, C.; Mustafa, W A
• Is Part Of: Journal of physics. Volume 1793:Issue 1(2021)
• Publication Date: 2021-02
• Subjects: Physics -- Congresses; 530.5
• DOI: 10.1088/1742-6596/1793/1/012071
• Languages: English
• ISSNs: 1742-6588

Abstract

Abstract: Power cables are very critical in electrical power systems as power cables failure can interrupt the electrical flow due to unexpected power failure. There are a few sorts of partial discharge (PD) estimations gadgets in the market. For instance, PD can be distinguished by utilizing Rogowski coil (RC) sensors in the disconnected procedure. The current issue PD signal does not usually occur as a single source. Thus, the analysis of multiple PD sources is required to ensure that the cable insulation is in a healthy condition. PD location technique based on multiple signals in 11kV underground power cable was conducted in this research to estimate the accurate location of the PD signal. Modelling of single power cable in a distance of 10km with the RC sensor is installed at several distances to capture the PD signal that travels along the power cable. By selecting the distance between six RC sensors and synchronous multiple PD signal, the design of the power system has been constructed by using EMTP-ATP software. Multi-point technique based on time difference of arrival (TDOA) was performed in the single line power cable to obtain the PD location. The measurement using multi-point of RC sensor technique is preferred based on the conditions due to the value of velocity elimination. Based on the results, the accurate location of PD Source 1 is detected 501 m along RC sensor A1 to RC sensor A3. In contrast, PD source 2 has been detected 2800.15 m along RC sensor A4 to RC sensor A6 with the percentage error of 0.2% and 0.0053%, respectively. The findings show that the location of multiple PD signal that occurred along the line cable can be detected accurately by using the multi-point technique and TDOA. Hence, the performance of the power system has been improved.