Multi-scale characterization of austenite reversion and martensite recovery in a cold-rolled medium-Mn steel. (March 2019)

• Record Type: Journal Article
• Authors: Benzing, J.T.; Kwiatkowski da Silva, A.; Morsdorf, L.; Bentley, J.; Ponge, D.; Dutta, A.; Han, J.; McBride, J.R.; Van Leer, B.; Gault, B.; Raabe, D.; Wittig, J.E.
• Is Part Of: Acta materialia. Volume 166(2019)
• Page Start: 512
• Page End: 530
• Publication Date: 2019-03
• Subjects: Austenite reversion -- Martensite recovery -- Medium-Mn steel -- FIB tomography -- 3D EBSD -- STEM EDS -- Atom probe tomography -- Thermo-Calc® -- DICTRA; Materials -- Periodicals; Materials science -- Periodicals; Materials -- Mechanical properties -- Periodicals; Metallurgy -- Periodicals; Chemistry, Inorganic -- Periodicals; 620.112
• DOI: 10.1016/j.actamat.2019.01.003
• Languages: English
• ISSNs: 1359-6454

Abstract

Abstract: A medium-Mn steel (Fe-12Mn-3Al-0.05C wt%) was designed using Thermo-Calc® simulations to balance the fraction and stacking fault energy of reverted austenite. Intercritical annealing for 0.5, 8 and 48 h was carried out at 585 °C to investigate the microstructural evolution. X-ray diffraction (XRD), electron backscatter diffraction (EBSD), 3-dimensional EBSD, energy-dispersive spectroscopy via scanning-transmission electron microscopy (STEM-EDS) and atom probe tomography (APT) enable characterization of phase fraction, grain area, grain morphology and alloy partitioning. An increase in annealing time from 0.5 h to 48 h increases the amount of ultrafine-grained (UFG) reverted austenite from 3 to 40 vol %. EBSD and TEM reveal multiple morphologies of UFG austenite (equiaxed, rod-like and plate-like). In addition, most of the remaining microstructure consists of recovered α′-martensite that resembles the cold-rolled state, as well as a relatively small fraction of UFG ferrite (i.e., only a small amount of martensite recrystallization occurs). Multi-scale characterization results show that the location within the cold-rolled microstructure has a strong influence on boundary mobility and grain morphology during austenite reversion. Results from APT reveal Mn-decoration of dislocation networks and low-angle lath boundaries in the recovered α′-martensite, but an absence of Mn-decoration of defects in the vicinity of austenite grains, thereby promoting recovery. STEM-EDS and APT reveal Mn depletion zones in the ferrite/recovered α′-martensite near austenite boundaries, whereas gradients of C and Mn co-partitioning are visible within some of the austenite grains after annealing for 0.5 h. Relatively flat C-enriched austenite boundaries are present even after 8 h of annealing and indicate certain boundaries possess low mobility. At later stages the growth of austenite followed the local equilibrium (LE) model such that the driving force between two equilibrium phases moves the mobile interface, as confirmed by DICTRA simulations (a Thermo-Calc® diffusion module). The sequence of austenite reversion is: (i) formation of Mn- and C-enriched face-centered-cubic nuclei from decorated dislocations and/or particles; (ii) co-partitioning of Mn and C and (iii) growth of austenite controlled by the LE mode. Graphical abstract: Image 1