Removal of residual compositions by powder engineering for high efficiency formamidinium-based perovskite solar cells with operation lifetime over 2000 h. (September 2021) - Tong, Guoqing
Abstract: Defects as a result of structural imperfections and/or extrinsic impurities in the perovskite films have a detrimental effect on efficiency and stability of perovskite solar cells (PSCs). Here, we propose to use pre-synthesized crystalline perovskite with perfect stoichiometry to control and lower the density of defects from precursors by the powder engineering method. Compared with raw materials (i.e., PbI2 and FAI) based perovskites, the average efficiency of the PSCs fabricated based on these pre-synthesized perovskite precursors increased from 18.62% to 19.85%. Moreover, the unwanted intermediate chemical compositions (i.e., the unreacted phases and residual solvent) in the raw material-based perovskite films were significantly reduced in the pre-synthesized δ-FAPbI3 and α-FAPbI3 perovskites according to the secondary ion mass spectroscopy depth profiling results. Finally, we obtained the champion efficiency of 22.76% for α-FAPbI3 and 23.05% for FAPb(I0.9 Br0.1 )3 based PSCs. Long-term operational stability measurements of the encapsulated FAPb(I0.9 Br0.1 )3 based PSCs showed a slow decay and maintained the efficiency about 88% after 1200 h (T80 > 2000 h). Furthermore, a proof-of-concept integrated perovskite solar module-lithium ion battery-light-emitting diode device was demonstrated. Graphical Abstract: Formamidinium-based perovskite solar cells with a high efficiency over 23% and 2000-h T80 lifetime were fabricated using pre-synthesized crystalline perovskite powders via powder engineering. ga1 Highlights: Pre-synthesized crystalline perovskite powder with fewer defects is prepared by the powder engineering method. Residual compositions are removed, which results in improved efficiency and operational stability. The highest PCEs of 22.76% for α-FAPbI3 and 23.05% for FAPb(I0.9 Br0.1 )3 are achieved by the powder engineering method. A proof-of-concept perovskite solar module-lithium ion battery-light-emitting diode (PSM-LIB-LED) device is demonstrated.