Effect of charging/discharging temperatures upon melting and solidification of PCM-metal foam composite in a heat storage tube. (February 2023)

• Record Type: Journal Article
• Authors: Shu, Gao; Xiao, Tian; Guo, Junfei; Wei, Pan; Yang, Xiaohu; He, Ya-Ling
• Is Part Of: International journal of heat and mass transfer. Volume 201:Part 2(2023)
• Publication Date: 2023-02
• Subjects: Passive building energy utilization -- Thermal energy storage -- Experiments -- Phase change materials -- Metal foam; Heat -- Transmission -- Periodicals; Mass transfer -- Periodicals; Chaleur -- Transmission -- Périodiques; Transfert de masse -- Périodiques; Electronic journals; 621.4022
• DOI: 10.1016/j.ijheatmasstransfer.2022.123555
• Languages: English
• ISSNs: 0017-9310

Abstract

Highlights: When the heating temperature is increased from 65.0 °C to 85.0 °C, the complete melting time is reduced by 56.0%. When the cooling temperature is reduced from 30.0 °C to 10.0 °C, the full solidification time is shortened by 40.0%. Increasing the temperature difference between the PCM and the heating/cooling fluid can enhance the temperature response rate but weaken the temperature uniformity in the PCM region. Abstract: Solar energy has addressed the significant issue of energy conservation and emission reduction through providing an alternative solution to the building energy utilization. To solve the inherent intermittency problem, latent heat phase change module is designed to even the fluctuation of energy supply. This paper designs a phase change heat storage/release unit and builds a visual test system for phase change heat storage/release. To study the influence of different heating and cooling temperatures upon thermal cycle of melting and solidification, a series of experiments are carried out. Melting front evolution, temperature field and response, and uniformity analysis are assessed. Experimental results demonstrate that the phase interface changes from top to bottom in the melting process. However, solidified covers appear evenly up and down during solidification process. Reasonably increasing the heating temperature effectively shortens the complete melting time. 56.0% reduction in full melting time is achieved if increasing the heating temperature from 65 °C to 85 °C. However, this is done at the expense of decreasing the temperature uniformity of the PCM. The results proved guidance for the design strategy on passive building energy utilization.