Cross-sectional behaviour of wire arc additively manufactured tubular beams. (1st December 2022)

• Record Type: Journal Article
• Authors: Huang, Cheng; Meng, Xin; Gardner, Leroy
• Is Part Of: Engineering structures. Volume 272(2022)
• Publication Date: 2022-12-01
• Subjects: Digital image correlation (DIC) -- Irregular hollow section -- Metal 3D printing -- Rectangular hollow section (RHS) -- Square hollow section (SHS) -- Wire arc additive manufacturing (WAAM); Structural engineering -- Periodicals; Structural analysis (Engineering) -- Periodicals; Construction, Technique de la -- Périodiques; Génie parasismique -- Périodiques; Pression du vent -- Périodiques; Earthquake engineering; Structural engineering; Wind-pressure; Periodicals; 624.105
• DOI: 10.1016/j.engstruct.2022.114922
• Languages: English
• ISSNs: 0141-0296

Abstract

Highlights: Fourteen WAAM stainless steel tubular beams were tested in four-point bending. 3D laser scanning and silicon casting were used to determine the specimen geometries. Digital image correlation (DIC) was employed to monitor the deformation responses. Test results were compared against conventional stainless steel tubular beams. Applicability of design provisions in EN 1994–1-4, AISC 370 and CSM was assessed. Abstract: Wire arc additive manufacturing (WAAM) is a promising metal 3D printing technique in the construction industry for its ability to produce large and complex-shaped elements, with reasonable printing accuracy, time and costs. There is currently, however, a lack of fundamental test data on the structural performance of WAAM elements. To address this, an experimental study into the cross-sectional behaviour of WAAM tubular beams has been conducted and is presented herein. A total of 14 stainless steel square, rectangular and irregular hollow sections, spanning over all cross-section classes of EN 1993-1-4 and AISC 370, were tested in four-point bending. 3D laser scanning, silicone casting and Archimedes' measurements were employed to collectively determine the as-built geometry and local geometric imperfections of the test specimens, while digital image correlation (DIC) was used to monitor the deformation responses of the specimens during testing. The full moment–curvature histories and key experimental results are presented and discussed. Similar cross-sectional behaviour to that of equivalent, conventionally manufactured sections was observed, with the more slender cross-sections showing increased susceptibility to local buckling. However, owing to the inherent geometric variability of WAAM, the tested 3D printed beams exhibited more variable flexural capacities between the repeat specimens than is generally displayed by conventionally produced stainless steel sections. Finally, the test results were used to assess the applicability of current cross-section design provisions in the European (EN 1993-1-4) and American (AISC 370) structural design specifications, as well as the continuous strength method (CSM), to WAAM stainless steel tubular beams.