A Feasibility Study on Use of an Accelerometer to Measure the Dynamic Forces in Turning. (September 2022)

• Record Type: Journal Article
• Authors: Raval, Jay; Randolph, Otto; Zvanut, Ryan; Tai, Bruce L.
• Is Part Of: Manufacturing letters. Volume 33(2022)Supplement
• Page Start: 404
• Page End: 409
• Publication Date: 2022-09
• Subjects: Cutting vibrations -- machine dynamics -- system identification -- Metrology; Manufacturing industries -- Periodicals; Production engineering -- Periodicals; Manufacturing industries; Periodicals; 670
• DOI: 10.1016/j.mfglet.2022.07.053
• Languages: English
• ISSNs: 2213-8463

Abstract

Abstract: Metal cutting is a highly dynamic process that generates continuously varying forces. Measurement of these forces is essential to characterizing a cutting process and to fully utilize the machine tool. A force dynamometer is often used to measure these varying forces; however, it is limited by the natural frequency of the sensor and can sometimes be hard to set up on a machine. Therefore, this study aims to estimate the dynamic component of the cutting force using an accelerometer placed directly below the cutting edge. The placement of the sensor helps achieving better signal to noise ratio (S/N). The cutting tool is modelled as a single degree of freedom (SDOF) system relative to the workpiece and dynamic loads are experimentally simulated on it. The measured acceleration is numerically integrated to obtain velocity and deflection, which along with the natural frequency ( ω n ) and damping ratio ( ζ ), is used to predict the dynamic load using the system equation. The dynamic forces tested over a wide range of frequencies, show good agreement with the data from simultaneous dynamometer measurement and the force estimated using the proposed method. The study shows the feasibility of this method in a real cutting scenario and the capability to apply it to a multi DOF system. One major limitation is the inability to capture the static or quasi-static component of the cutting force.