Fuel inventory and deposition in castellated structures in JET-ILW. (26th April 2017)

• Record Type: Journal Article
• Authors: Rubel, M.; Petersson, P.; Zhou, Y.; Coad, J.P.; Lungu, C.; Jepu, I.; Porosnicu, C.; Matveev, D.; Kirschner, A.; Brezinsek, S.; Widdowson, A.; Alves, E.
• Other Names: collab.
• Is Part Of: Nuclear fusion. Volume 57:Number 6(2017:Jun.)
• Publication Date: 2017-04-26
• Subjects: JET -- ITER-like wall -- beryllium limiters -- castellation -- deposition -- fuel inventory; Nuclear fusion -- Periodicals; 621.48405
• DOI: 10.1088/1741-4326/aa6864
• Languages: English
• ISSNs: 0029-5515

Abstract

Abstract: Since 2011 the JET tokamak has been operated with a metal ITER-like wall (JET-ILW) including castellated beryllium limiters and lamellae-type bulk tungsten tiles in the divertor. This has allowed for a large scale test of castellated plasma-facing components (PFC). Procedures for sectioning the limiters into single blocks of castellation have been developed. This facilitated morphology studies of morphology of surfaces inside the grooves for limiters after experimental campaigns 2011–2012 and 2013–2014. The deposition in the 0.4–0.5 mm wide grooves of the castellation is 'shallow'. It reaches 1–2 mm into the 12 mm deep gap. Deuterium concentrations are small (mostly below 1 × 10 18 cm −2 ). The estimated total amount of deuterium in all the castellated limiters does not exceed the inventory of the plasma-facing surfaces (PFS) of the limiters. There are only traces of Ni, Cr and Fe deposited in the castellation gaps. The same applies to the carbon content. Also low deposition of D, Be and C has been measured on the sides of the bulk tungsten lamellae pieces. Modelling clearly reflects: (a) a sharp decrease in the measured deposition profiles and(b) an increase in deposition with the gap width. Both experimental and modelling data give a strong indication and information to ITER that narrow gaps in the castellated PFC are essential. X-ray diffraction on PFS has clearly shown two distinct composition patterns: Be with an admixture of Be–W intermetallic compounds (e.g. Be22 W) in the deposition zone, whilst only pure Be has been detected in the erosion zone. The lack of compound formation in the erosion zone indicates that no distinct changes in the thermo-mechanical properties of the Be PFC might be expected.