Torsional strength of RC members using a plasticity-based variable-angle space truss model accounting for non-uniform longitudinal reinforcement. (1st February 2021)

• Record Type: Journal Article
• Authors: De Domenico, Dario
• Is Part Of: Engineering structures. Volume 228(2021)
• Publication Date: 2021-02-01
• Subjects: Reinforced concrete beam -- Torsional strength -- Variable angle truss model -- Torque -- Space truss model -- Thin-walled tube analogy -- Plasticity theory -- Concrete compression struts -- Transverse reinforcement -- Longitudinal reinforcement; Structural engineering -- Periodicals; Structural analysis (Engineering) -- Periodicals; Construction, Technique de la -- Périodiques; Génie parasismique -- Périodiques; Pression du vent -- Périodiques; Earthquake engineering; Structural engineering; Wind-pressure; Periodicals; 624.105
• DOI: 10.1016/j.engstruct.2020.111540
• Languages: English
• ISSNs: 0141-0296

Abstract

Highlights: Torsional model for RC members with non-uniform longitudinal reinforcement along walls. Ultimate strut inclination angles determined via lower-bound theorem of plasticity. Normalized torsional strength curves in terms of dimensionless reinforcement indexes. Good agreement with experimental results of RC members under pure torsion. Improved accuracy for RC members with markedly non-uniform longitudinal reinforcement arrangement. Abstract: The torsional strength of reinforced concrete (RC) members is typically calculated through the thin-walled tube, space truss analogy. The governing equations are simple equilibrium conditions satisfied by closed stirrups, longitudinal reinforcement and spiral concrete diagonals at a variable angle. In building codes, like EC2 and ACI 318, the contribution of longitudinal reinforcement is averaged among the walls, considering the total amount of longitudinal re-bars of the overall cross section. However, longitudinal re-bars may be non-uniformly distributed along the walls. This is particular evident in beams with large aspect ratios and re-bars mainly located at the corners, or in beams with unsymmetrical bending-type longitudinal reinforcement arrangement. This paper presents a plasticity-based variable-angle space truss model accounting for non-uniform distribution of longitudinal reinforcement along the walls. The model, which is based on equilibrium conditions and the lower-bound theorem of plasticity, is first elaborated for a polygonal cross-section with an arbitrary number of walls incorporating arbitrary longitudinal reinforcement ratios and corresponding variable-angle concrete strut inclinations, and then particularized to the more common case of rectangular section with two representative longitudinal reinforcement ratios and two corresponding variable-angle strut inclinations. For practical design purposes, the results of this model are illustrated through normalized torsional strength curves in terms of non-dimensional reinforcement indexes. The model is validated by comparison with more than 200 experimental results of RC members under pure torsion collected from the literature, and very good agreement is found. The predictions of the model are also compared with those of some codes of practice and better results are obtained especially for beams with markedly non-uniform longitudinal reinforcement arrangement.