Investigation of drag and heat reduction induced by a novel combinational lateral jet and spike concept in supersonic flows based on conjugate heat transfer approach. (January 2018)

• Record Type: Journal Article
• Authors: Zhu, Liang; Chen, Xiong; Li, Yingkun; Musa, Omer; Zhou, Changsheng
• Is Part Of: Acta astronautica. Volume 142(2018)
• Page Start: 300
• Page End: 313
• Publication Date: 2018-01
• Subjects: Lateral jet -- Spike -- Conjugate heat transfer -- Drag reduction -- Supersonic flow; Astronautics -- Periodicals; Outer space -- Exploration -- Periodicals; Astronautics; Periodicals; 629.405
• DOI: 10.1016/j.actaastro.2017.11.001
• Languages: English
• ISSNs: 0094-5765

Abstract

Abstract: When flying at supersonic or hypersonic speeds through the air, the drag and severe heating have a great impact on the vehicles, thus the drag reduction and thermal protection studies have attracted worldwide attention. In the current study, the Reynolds-averaged Navier-Stokes (RANS) equations coupled with the shear stress transport (SST) k − ω turbulence model have been employed to investigate the flow behavior induced by a novel combinational lateral jet and spike concept in supersonic flows. A coupling conjugate heat transfer (CHT) approach has been applied to investigate the thermal protection, which takes the heat transfer of structure into consideration. After the code was validated by the available experimental results and the gird independency analysis was carried out, the influences of the spike length ratio, lateral jet pressure ratio and lateral jet location on the drag and heat reduction performance are analyzed comprehensively. The obtained results show that a remarkable reduction in the drag and heat flux is achieved when a lateral jet is added to the spike. This implies that the combinational lateral jet and spike concept in supersonic flows have a great benefit to the drag and heat reduction. Both the drag and heat reduction decrease with the increase of the lateral jet pressure ratio, and the heat flux is more sensitive to the lateral jet pressure ratio. The lateral jet should not be located in the bottom of the spike in order to realize better drag and heat reduction performance. The drag and heat flux could be reduced by about 45% by reasonable lateral jet location. The drag decreases with the increase of the spike length ratio whereas the heat flux is affected by the spike length ratio just in a certain range. Highlights: An in-house code was developed to analyze the drag and heat reduction. A novel combinational lateral jet and spike concept was numerically investigated. Conjugate heat transfer approach was applied to perform a fluid-thermal analysis. A new parameter was introduced to study the influence of lateral jet location. Significant decreases of the drag and heat flux are both observed in results.