Effects of grain refinement on the quasi-static compressive behavior of AISI 321 austenitic stainless steel: EBSD, TEM, and XRD studies. (August 2018)

• Record Type: Journal Article
• Authors: Tiamiyu, A.A.; Tari, Vahid; Szpunar, J.A.; Odeshi, A.G.; Khan, A.K.
• Is Part Of: International journal of plasticity. Volume 107(2018:Aug.)
• Page Start: 79
• Page End: 99
• Publication Date: 2018-08
• Subjects: AISI 321 austenitic stainless steel -- Electron microscopy -- Twinning -- Phase transformation -- Strengthening mechanisms -- VPSC; Plasticity -- Periodicals; Plasticité -- Périodiques; Plasticity; Periodicals; 620.11233
• DOI: 10.1016/j.ijplas.2018.03.014
• Languages: English
• ISSNs: 0749-6419

Abstract

Abstract: The effects of grain refinement on the quasi-static compressive behavior of AISI 321 austenitic stainless steel (ASS) were studied. The effect of strain on the final microstructure after compressive deformation was also investigated. The compression tests on steel specimens were conducted at a strain rate of 4.2 × 10 −3 s −1 . Ultrafine-grained (UFG) specimen with the grain size of 0.24 μm exhibits an excellent combination of high yield strength (∼1 GPa) and good strain hardenability. Meanwhile, the coarse-grained (CG) specimen with the grain size of 37 μm exhibits yield strength of ∼0.2 GPa. At 0.53 true strain, UFG and CG specimens exhibit compressive strengths of 5.95 and 4.80 GPa, respectively. The Hall-Petch relation constants, σ o, and K, for the AISI 321 ASS were estimated to be 128 MPa and 478 MPa μm −0.5, respectively. The strain hardening behavior of both UFG and CG specimens occur in three distinctive stages. CG specimen exhibits higher strain hardening rate than the UFG specimen up to a critical true strain of 0.4, above which strain hardening rate in UFG becomes greater. X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscope (TEM) techniques were used for microstructural analyses to understand the underlying mechanisms behind the strain hardening behavior. Texture evolution during deformation, orientation relationship between phases and the sequence of martensitic phase transformation were also studied and are discussed in this paper. Visco-plastic self-consistent (VPSC) modeling was employed to decipher the role of deformation mechanisms in macroscopic stress-strain response and also in texture evolution during uniaxial compression loading. Highlights: Effect of grain refinement on compressive behavior of AISI 321 was studied. Yield strength in UFG (0.24 μm) and CG (37 μm) samples are ∼1 and ∼0.2 GPa, resp. CG exhibits higher hardening rate than UFG up to a critical true strain of 0.4 Strain-induced transformation follows both FCC γ .→ BCC αʹ and FCC γ → HCP ɛ→ BCC αʹ VPSC results deviate from experiment in CG and UFG at strains of 0.23 and 0.16, resp.