Nitrogen Oxide Emissions from Premixed Reacting Jets in a Vitiated Crossflow. Issue 7 (2nd July 2020)

• Record Type: Journal Article
• Authors: Sirignano, M. D.; Nair, V.; Emerson, B. L.; Seitzman, J.; Lieuwen, T. C.
• Is Part Of: Combustion science and technology. Volume 192:Issue 7(2020)
• Page Start: 1389
• Page End: 1419
• Publication Date: 2020-07-02
• Subjects: NOx emissions -- axial staging -- reacting jet in crossflow -- flame lifting -- hydrodynamic stability; Combustion -- Periodicals; Combustion engineering -- Periodicals; 541.36105
• DOI: 10.1080/00102202.2020.1748016
• Languages: English
• ISSNs: 0010-2202

Abstract

ABSTRACT: This paper describes nitrogen oxide (NOx) measurements from a reacting jet in crossflow (RJICF). The NOx production of the RJICF is controlled by jet stoichiometry, crossflow temperature and composition, and the mixing rates between the fluid streams. Mixing occurs both pre- and post-flame. Pre-flame mixing refers to mixing between the reactant jet and the crossflow prior to combustion and determines the stoichiometry of burning; it is controlled by degree of flame lifting, LO, and the shear layer vortices. Post-flame mixing refers to mixing of these secondary combustion products with the crossflow; it is controlled by the counter-rotating vortex pair. The literature has clearly shown a monotonic increase in RJICF NOx production with its bulk average temperature rise (ΔT) but also indicated significant dependencies on momentum flux ratio ( J ), jet stoichiometry ( ϕjet ), and other parameters. Moreover, these parameters are always coupled for a given geometry (e.g., LO varies with ϕjet ), and the fundamental influence parameters require clarification. To address this, significant effort was spent in this work on differentiating these coupled effects. NOx measurements were obtained from premixed ethane/methane/air jets injected into a vitiated crossflow of lean combustion products, for Δ T values between 75 and 350 K. Data were obtained at two crossflow temperatures (1350 K and 1410 K), two jet geometries, J values from 6 to 40, and ϕjet from 0.8 to 8.0. Ethane/methane ratio was varied to influence flame lifting independent of other parameters. Jet geometry was varied to influence shear layer vortex growth rates and, hence, pre-flame mixing rates. Overall, these data are consistent with the idea that NOx emissions are largely controlled by the stoichiometry at which combustion actually occurs, referred to as ϕFlame . ϕFlame is influenced by ϕjet and pre-flame mixing of the jet and crossflow that, in turn, depend upon LO, nozzle geometry, and crossflow temperature. While this result is expected, it manifests itself in complex manners. For example, NOx levels were observed to be nearly independent of ϕjet for a range of conditions, due to the coupled dependence of ϕjet and LO . Similarly, NOx emissions are a factor of three lower in the nozzle jet geometry relative to a fully developed exit flow, due to enhanced pre-flame mixing. From a practical point of view, the key implication of these results is its suggestion for minimizing NOx production at a given Δ T – designing injection schemes that enhance flame lifting and shear layer vortex growth rates. Finally, there are indications in the data of additional post-flame mixing effects that require further work to clarify.