Effects of layer thickness in laser-powder bed fusion of 420 stainless steel. Issue 7 (24th June 2020)

• Record Type: Journal Article
• Authors: Nath, Subrata Deb; Gupta, Gautam; Kearns, Martin; Gulsoy, Ozkan; Atre, Sundar V.
• Is Part Of: Rapid prototyping journal. Volume 26:Issue 7(2020)
• Page Start: 1197
• Page End: 1208
• Publication Date: 2020-06-24
• Subjects: Layer thickness -- Laser-powder bed fusion -- Stainless steel -- Ultimate tensile strength -- Corrosion; Engineering design -- Periodicals; 620.004205
• DOI: 10.1108/RPJ-10-2019-0279
• Languages: English
• ISSNs: 1355-2546

Abstract

Abstract : Purpose: The purpose of this paper is to investigate effects of layer thickness on densification, surface morphology, microstructure and mechanical and corrosion properties of 420 stainless steel fabricated by laser-powder bed fusion (L-PBF). Design/methodology/approach: Standard specimens were printed at layer thickness of 10, 20 and 30 µm to characterize Archimedes density, surface roughness, tensile strength, elongation, hardness, microstructural phases and corrosion performance in the as-printed and heat-treated condition. Findings: Archimedes density slightly increased from 7.67 ± 0.02 to 7.70 ± 0.02g/cm 3 and notably decreased to 7.35 ± 0.05 g/cm 3 as the layer thickness was changed from 20 µm to 10 and 30 µm, respectively. The sensitivity to layer thickness variation was also evident in properties, the ultimate tensile strength of as-printed parts increased from 1050 ± 25 MPa to 1130 ± 35 MPa and decreased to 760 ± 35 MPa, elongation increased from 2.5 ± 0.2% to 2.8 ± 0.3% and decreased to 1.5 ± 0.2, and hardness increased from 55 ± 1 HRC to 57 ± 1 HRC and decreased to 51 ± 1 HRC, respectively. Following heat treatment, the ultimate tensile strength and elongation improved but the general trends of effects of layer thickness remained the same. Practical implications: Properties obtained by L-PBF are superior to reported properties of 420 stainless steel fabricated by metal injection molding and comparable to wrought properties. Originality/value: This study successfully the sensitivity of mechanical and corrosion properties of the as-printed and heat-treated parts to not only physical density but also microstructure (martensite content and tempering), as a result of changing the layer thickness. This manuscript also demonstrates porosity evolution as a combination of reduced energy flux and lower packing density for parts processed at an increasing layer thickness.