Analysis of time dependent thermal properties for high rates in selective laser sintering. Issue 5 (14th June 2018)

• Record Type: Journal Article
• Authors: Wudy, Katrin; Drexler, Maximilian; Lanzl, Lydia; Drummer, Dietmar
• Is Part Of: Rapid prototyping journal. Volume 24:Issue 5(2018)
• Page Start: 894
• Page End: 900
• Publication Date: 2018-06-14
• Subjects: Selective laser sintering -- Degradation -- Heating rate -- Polyamide 12 -- Laser-HS-DSC -- Maximum temperature; Engineering design -- Periodicals; 620.004205
• DOI: 10.1108/RPJ-01-2017-0013
• Languages: English
• ISSNs: 1355-2546

Abstract

Abstract : Purpose: The thermal history during laser exposure determines part properties in selective laser sintering (SLS). The purpose of this study is to introduce a new measurement technique based on a CO2 laser unit combined with a high-speed DCS. A first comparison of the thermal history during laser exposure measured with Laser-high-speed-(HS)-differential scanning calorimetry-(DSC) and in SLS process is shown. Design/methodology/approach: This Laser-HS-DSC allows an imitation of the SLS-process in a very small scale, as the sample is directly heated by a CO2 laser. For this study, the laser power and the impact time is varied for determining temperature and achieved heating rates. Consequently, the temperature levels measured by the Laser-HS-DSC are compared with measurements in SLS-process. Findings: The influence of laser power and impact time on resulting maximum temperatures und heating rates during laser exposure are investigated. With increasing laser power and impact time the maximum temperature rises up to approximately 450°C without material degradation. The heating rate increases up to an impact time of 3 ms and stays almost equal for higher durations. Research limitations/implications: The Laser-HS-DSC experiments are based on few particles limiting a complete comparison with SLS process. In SLS, one volume element is exposed several times. In this study the PA12 material was exposed only once. Originality/value: For the first time, laser sintering experiments can be transferred to a laboratory scale to analyze the influence of laser exposure on resulting temperature field during laser exposure without superimposing effects.