Effect of wettability on pool boiling heat transfer with copper microporous coated surface. (15th September 2022) - Wang, Xiaomeng
Highlights: Experimental investigation of the effect of surface wettability and microporous coating on nucleate boiling performance. Pool boiling with water and surface wettability ranging between superhydrophilic to hydrophobic. Higher CHF but lower h due to enhanced wettability with oxidized Cu-HTCMC surface over a pristine microporous surface. Improved boiling heat transfer and delayed dryout by expanding the vapor film over an entire extended hydrophobic surface. Abstract: Microporous coated surfaces significantly enhance nucleate boiling heat transfer performance over plain surfaces. Pool boiling experiments are performed on a copper high-temperature, thermally-conductive, microporous coating (Cu-HTCMC) with altered surface wettability. The combined effect of surface wettability and microporous coating on nucleate boiling performance is experimentally investigated on copper surfaces. Specifically, the surface condition is pristine, oxidized, and Teflon-coated, yielding a surface wettability ranging between superhydrophilic (∼0° apparent contact angle) to hydrophobic (131° apparent contact angle). The experimental results show that the hydrophobic microporous surface promotes early bubble incipience, yielding a high heat transfer coefficient at low heat flux. However, with enhanced wettability, the hydrophilic microporous surfaces result in high critical heat flux. The enhanced wettability of the oxidized Cu-HTCMC surface offers a 19% increase in CHF (2350 kW/m 2 ) over the pristine microporous surface, but the corresponding heat transfer coefficient for the pristine Cu-HTCMC surface (466 kW/m 2 K) is 37% higher than the oxidized. The trends are found to be consistent with plain copper surfaces, where the enhanced wettability (oxidized plain surface) offers a 57% increase in CHF over the pristine plain surface but h for the pristine is 9% higher at CHF.