Effect of metal oxide particles on the flow and forced convective heat transfer behaviour of microencapsulated PCM slurry. (15th May 2022) - Zhang, Guanhua
Highlights: The addition of metal oxide particles greatly improves the thermal conductivity of MPCS. MPCS with metal oxide particles can enhance heat transfer under different flow conditions. Heating power and flow rates are crucial to the heat transfer of MPCS. MPCS with metal oxide particles can be used as heat transfer medium and energy storage fluid. Abstract: ZnO, nano ZnO and nano Al2 O3 were mixed with microencapsulated phase change material slurry (MPCS) for improving the heat transfer performance of slurries in this paper. The thermal and rheological properties of MPCS were measured using DSC, thermal conductivity meter and rheometer. The results show that the thermal conductivity of 5 wt% MPCS with 1 wt% ZnO, nano ZnO and nano Al2 O3 was 17.9 %, 19.4 % and 23.5 % higher than that of 5 wt% MPCS, respectively. The forced convection heat transfer experiment of slurries was carried out in a loop system with various heat flux and flow conditions. The influences of heat flux, flow rate and metal oxide particles on the flow and heat transfer behaviour of slurries were investigated. The results show that the heat transfer was significantly enhanced for all slurries with metal oxide particles under three flow conditions. Compared with water, the local heat transfer coefficient ( hx ) of MPCSs with 1 wt% ZnO, nano ZnO and nano Al2 O3 increased by 6.5 %, 9.1 % and 12.4 % under laminar flow, 6.6 %, 15.5 % and 14.9 % under transition flow, and 15.7 %, 19.0 % and 21.6 % in turbulent condition, respectively.