Energy level matching between transparent conducting electrodes and the electronic transport layer to enhance performance of all-inorganic CsPbBr3 solar cells. (June 2022)

• Record Type: Journal Article
• Authors: Guo, Ruxin; Zhao, Yan; Deng, Quanrong; Zhang, Yongshang; Wu, Zhiheng; Duan, Yanyan; Zhang, Wei; Shen, Yonglong; Shao, Guosheng
• Is Part Of: Vacuum. Volume 200(2022)
• Publication Date: 2022-06
• Subjects: Ta-doped SnO2 -- HiTUS -- Energy level matching -- Surface roughness -- CsPbBr3 perovskite solar cells; Vacuum -- Periodicals; 621.55
• DOI: 10.1016/j.vacuum.2022.111028
• Languages: English
• ISSNs: 0042-207X

Abstract

Abstract: Perovskite solar cells (PSCs) have become a promising research direction in photovoltaic field, where the evolution of the transparent conductive oxides (TCOs) electrodes, a vital part of photovoltaic devices, has played a distinctive role in their development. To date, the indium tin oxide (ITO) and fluorine-doped tin oxide (FTO) have been widely used as TCOs in state-of-the-art PSCs. However, the energy level matching between the TCO electrodes and the electron transport layers (ETLs) are usually ignored. Herein, Ta doped SnO2 (TTO) films have been prepared by the high target utilisation sputtering (HiTUS) technology, which exhibited the lowest resistivity of 7.8 × 10 −4 Ω cm and the average transmittance in the visible light region over 85%. A maximum power conversion efficiency (PCE) with 6.48% was achieved when the TTO films as the bottom electrodes in CsPbBr3 PSCs, higher than that of PSCs based on FTO (5.36%). Especially, the open-circuit voltage ( V oc ), short-circuit current ( J sc ) and fill factor ( FF ) were all enhanced, which were attributed to the suitable energy level matching between the TCOs and ETLs layers and their low interface roughness. This work demonstrates the band structure of the TCOs and ETL layers and the roughness of TCOs have more important influence on the PCE of PSCs under the similar optical and electrical properties of TCOs condition. Highlights: Ta doped SnO2 films show the resistivity of 7.8 × 10 −4 Ω cm and transmittance of 85%. The films were used as TCOs in CsPbBr3 solar cell, which showed PCE of 6.48%. The band structure of TCOs has an important influence on the efficiency of PSCs.