Drivetrain resistance and starting performance of a small wind turbine. (March 2018)

• Record Type: Journal Article
• Authors: Vaz, Jerson R.P.; Wood, David H.; Bhattacharjee, Debanik; Lins, Erb F.
• Is Part Of: Renewable energy. Volume 117(2018)
• Page Start: 509
• Page End: 519
• Publication Date: 2018-03
• Subjects: Starting friction torque -- Dynamic modeling -- Wind turbine -- Blade element theory; Renewable energy sources -- Periodicals; Power resources -- Periodicals; Énergies renouvelables -- Périodiques; Ressources énergétiques -- Périodiques; 333.794
• DOI: 10.1016/j.renene.2017.10.071
• Languages: English
• ISSNs: 0960-1481

Abstract

Abstract: Most small wind turbines do not have pitch adjustment of the blades. This makes starting at low wind speed a serious challenge which is magnified by the drivetrain resistance caused by bearing friction, generator cogging torque and so on. Typically the resistive torque is much less than the rated generator torque so drivetrain resistance is safely ignored once power production commences but must be considered when the rotor torque is low. This occurs during starting and when the turbine approaches the runaway condition of no output load. Equations are derived here for the drivetrain resistance of a small turbine as part of an analysis of starting and runaway which is compared to wind tunnel measurements. This paper focuses on the resistance due to the bearings in the drivetrain, especially on the transition from high static to significantly lower dynamic resistance as high static resistance increases the wind speed at which a turbine starts. The measurements were made using a three-bladed turbine with no other loads so they include both starting performance and runaway. The results demonstrate a static resistive torque about seven times the dynamic one, giving a theoretical starting wind speed of 4.20 m/s which is 6% higher than the measured value. Good agreement is found between the analysis and measurements of rotor angular velocity over the whole operating range from starting to runaway, highlighting the importance of this work for estimating the minimum wind speed for the starting of small wind turbines. Highlights: New formulations for the drivetrain frictional resistance were developed. The starting performance of a small wind turbine was analyzed using blade element theory. The resistive torque of the turbine drivetrain was measured. The effects of the friction torque of bearings are assessed adding the Stribeck model. The measured starting performance of the turbine is in good agreement with the model.