Determination of S-N fatigue curves for damaged steel plates strengthened with prestressed CFRP plates under tension loading. (15th November 2018)

• Record Type: Journal Article
• Authors: Ye, Huawen; Shuai, Chun; Zhang, Xun; Xu, Xun; Ummenhofer, Thomas
• Is Part Of: Engineering structures. Volume 175(2018)
• Page Start: 669
• Page End: 677
• Publication Date: 2018-11-15
• Subjects: Steel structure -- Strengthening -- Prestressed CFRP plate -- S-N fatigue curve -- R-ratio -- Prestress level; Structural engineering -- Periodicals; Structural analysis (Engineering) -- Periodicals; Construction, Technique de la -- Périodiques; Génie parasismique -- Périodiques; Pression du vent -- Périodiques; Earthquake engineering; Structural engineering; Wind-pressure; Periodicals; 624.105
• DOI: 10.1016/j.engstruct.2018.08.075
• Languages: English
• ISSNs: 0141-0296

Abstract

Highlights: A S-N fatigue curve determination is obtained for notched steel plates repaired with CFRP plates. The recommended values of constant C and m are 6.86 × 10 −12 and 3.0 for mild steel in reinforcements. The practical value U of crack closure effect is recommended as 1.0 in the negative region ( R < −0.5). Abstract: To promote a straightforward design guideline, a determination model of S-N fatigue curves was established to consider effects of the initial crack and stress ratio ( R -ratio) on the fatigue performance of damaged steel plates strengthened with non- and prestressed CFRP (Carbon Fiber-reinforced Polymer) plates. The modified Paris' law employing the effective stress intensity factor range was first used to model the fatigue crack growth data obtained from an extensive literature review for various R -ratios, including edge- and center-notched reinforced steel plates under fatigue loadings. Based on these analysis, the fatigue S-N curve function including the fatigue strength Δ σc and fatigue threshold Δ σL, was derived to consider the effects of the initial crack and R -ratio. The model was validated using fatigue results of approximately two hundred specimens with various notch sizes and stress ratios. Specific handbooks provided distinctly different values of C and m for mild steel, and among them the recommended values are 6.86 × 10 −12 (with the unit of MPa and meter) and 3.0 through the validation using existing test data reported in the literatures. The comparison of the experimental and predicted fatigue lives confirms the feasibility of the proposed S-N curve determination. Furthermore, the practical value U of the crack closure effect is recommended as 1.0 in the negative R region ( R < −0.5) considering the crack closure effect would be overestimated. The sensitivity analysis of critical factors also shows that the initial damage level dramatically influences the S-N curve, and the prestress level also has a dominant impact not only on the reduction of stress range but also the upgrade of fatigue threshold.