Independent changes in bone mineralized and marrow soft tissues following acute knee injury require dual-energy or high-resolution computed tomography for accurate assessment of bone mineral density and stiffness. (March 2022) - de Bakker, Chantal M.J.
Abstract: Musculoskeletal injuries often induce local accumulation of blood and/or fluid within the bone marrow, which is detected on medical imaging as edema-like marrow signal intensities (EMSI). In addition to its biological effects on post-injury recovery, the displacement of low-attenuating, largely adipocytic marrow by EMSI may introduce errors into quantitative computed tomography (QCT) measurements of bone mineral density (vBMD) and resulting bone stiffness estimates from image-based finite element (FE) analysis. We aimed to investigate the impact of post-injury changes in marrow soft tissue composition on CT-based bone measurements by applying CT imaging at multiple spatial resolutions. To do so, dual energy QCT (DECT) material decomposition was used to detect EMSI in the tibiae of nineteen participants with a recent anterior cruciate ligament tear. We then measured bone density and FE-based apparent modulus within the EMSI region and in a matched volume in the uninjured contralateral knee. Three measurement methods were applied: 1.) standard, QCT density calibration and density-based FEM; 2.) a DECT density calibration that provides density measurements adjusted for marrow soft tissues; and 3.) high-resolution peripheral QCT (HR-pQCT) density and microFE analyses. When measured using standard, single-energy QCT, vBMD and apparent modulus were elevated in the EMSI compared to the contralateral. After adjusting for marrow soft tissue composition using DECT, these measurements were no longer different between the two regions. By allowing for high-resolution, localized density analysis, HR-pQCT indicated that trabecular tissue mineral density was 9 mgHA/cm 3 lower, while density of marrow soft tissues was 18 mgHA/cm 3 higher, in the EMSI than the contralateral region, suggesting that EMSI have opposite effects on the measured density of trabecular bone and the underlying soft marrow. Thus, after an acute injury, altered composition of marrow soft tissues may artificially inflate overall measurements of bone density and apparent modulus obtained using standard QCT. This can be corrected by accounting for marrow soft tissue attenuation, either by using DECT-based density calibration or HR-pQCT microFE and measurements of local density of trabeculae. Graphical abstract: Image 1 Highlights: Post-injury, bone marrow edema increases CT attenuation of marrow soft tissues. Elevated soft tissue attenuation affects bone density and stiffness measurements. Dual energy CT measures bone density and stiffness adjusted for marrow composition. HR-pQCT provides local evaluation of mineralized vs. soft tissue density.