Electromagnetic wave absorption properties of polymer-derived magnetic carbon-rich SiCN-based composite ceramics. Issue 4 (15th February 2022)

• Record Type: Journal Article
• Authors: Wang, Shan; Ashfaq, M. Zeeshan; Qi, Desheng; Yue, Xigui; Gong, Hongyu
• Is Part Of: Ceramics international. Volume 48:Issue 4(2022)
• Page Start: 4986
• Page End: 4998
• Publication Date: 2022-02-15
• Subjects: Polymer derivation method -- SiCN-Based composite ceramics -- Magnetic carbon-rich -- Electromagnetic wave absorption performance; Ceramics -- Periodicals; Céramique industrielle -- Périodiques; Ceramics; Periodicals; Electronic journals; 666
• DOI: 10.1016/j.ceramint.2021.11.036
• Languages: English
• ISSNs: 0272-8842

Abstract

Abstract: In this paper, the mixture of Fe and Ni nanoparticles (abbreviated as FeNi) was added to liquid polysilazane (PSZ) as a magnetic source, to prepare a series of magnetic carbon-rich SiCN-based composite ceramics by adjusting the mass ratio of FeNi through the polymer derivation method. The phase composition, microstructure, conductivity, electromagnetic wave (EMW) absorption performance and mechanism of composite ceramics prepared were discussed. The analysis shows that the introduction of magnetism has adjusted the impedance matching and improved the magnetic loss performance of composite ceramics on the whole, and the dielectric loss ability of composite ceramics has been strengthened benefiting from the formation of conductive path of CNTs precipitated by FeNi catalysis in the matrix. Therefore, the addition of magnetic particles improves the EMW absorption peak intensity and effective absorption bandwidth (EAB) of composite ceramics. When the addition amount of FeNi was 5 wt%, the sample 5# exhibited the best comprehensive EMW absorption performance: Its minimum reflection loss (RLmin ) was −18 dB and the EAB was 2.5 GHz when the thickness was 1 mm, the EAB covering the C, X and Ku bands can be obtained by adjusting the thickness from 1.0 mm to 4.0 mm. Through calculation, the EAB (EABtf ) of 5# with a thickness of 1 mm and a filling rate of 1 wt% can reach 50, which is significantly higher than that of a series of SiCN-based composite ceramics previously reported. In addition, the density of 5# was 2.3 g/cm 3, and its compressive strength (CS) can reach 337 MPa. The data shows that the composite ceramic 5# prepared in this experiment has the merits of light weight, excellent comprehensive EMW absorption performance and good compression resistance, and is expected to be one of the promising materials in the field of new-generation EMW absorbers.