A comparison of pad metallization in miniaturized microfabricated silicon microcantilever-based wafer probes for low contact force low skate on-wafer measurements. (8th December 2021)

• Record Type: Journal Article
• Authors: Daffe, Khadim; Marzouk, Jaouad; Boyaval, Christophe; Dambrine, Gilles; Hadaddi, Kamel; Arscott, Steve
• Is Part Of: Journal of micromechanics and microengineering. Volume 32:Number 1(2022)
• Publication Date: 2021-12-08
• Subjects: microelectromechanical systems -- silicon microsystems -- microcantilever -- on-wafer probe -- contact resistance -- microwave probe -- microfabrication; Microelectromechanical systems -- Periodicals; Micromechanics -- Periodicals; 621.38105
• DOI: 10.1088/1361-6439/ac3cd7
• Languages: English
• ISSNs: 0960-1317

Abstract

Abstract: Miniaturized, microfabricated microelectromechanical systems-based wafer probes are used here to evaluate different contact pad metallization at low tip forces (<mN) and low skate on the on-wafer pads. The target application is low force RF probes for on-wafer measurements which cause minimal damage to both probes and pads. Low force enables the use of softer, more conductive metallisation. We have studied four different thin film contact pad metals based on their thin film electrical resistivity and micro-hardness: gold, nickel, molybdenum, and chromium. The contact pads sizes were micrometre (1.9 × 1.9 µ m 2 ) and sub-micrometre (0.6 × 0.6 µ m 2 ). The contact resistance of Au–Au, Ni–Au, Mo–Au, and Cr–Au was measured as a function of tip deflection. The tip force (loading) of the contacts was evaluated from the deflection of the cantilever. It was observed that an overtravel of 300 nm resulting in a contact force of ∼400 µ N was sufficient to achieve a contact resistance <1 Ω for a sub-micrometre gold contact pad. Our results are compared with an analytical model of contact resistance in loaded metal-metal contacts—a reasonable fit was found. A larger contact resistance was observed for the other metals—but their hardness may be advantageous when probing other materials. Using a combination of a rigid silicon cantilever (>1000 Nm −1 ) and small contact pads enabled us to show that it is the length of the pad (in contact with the surface) which determines the contact resistivity rather than the total contact pad area.