Parametric study of bone drilling by the Kirschner wire. (December 2021)

• Record Type: Journal Article
• Authors: Song, Shaokang; Cheng, Xiang; Li, Tao; Shi, Ming; Zheng, Guangming; Liu, Huanbao
• Is Part Of: Medical engineering & physics. Volume 98(2021)
• Page Start: 115
• Page End: 124
• Publication Date: 2021-12
• Subjects: Kirschner wire -- Cortical bone -- Drilling force -- Delamination factor -- Burr; Biomedical engineering -- Periodicals; Biomedical Engineering -- Periodicals; Physics -- Periodicals; Génie biomédical -- Périodiques; Biomedical engineering; Electronic journals; Periodicals; 610.28
• DOI: 10.1016/j.medengphy.2021.11.005
• Languages: English
• ISSNs: 1350-4533

Abstract

Highlights: Research on Kirschner wire bone drilling by RSM. Established drilling force, delamination factor, and hole exit burr height models through analysis of variance. The influence of Kirschner wire bevel angle, speed and feed rate on drilling force and drilling quality is analyzed through response surface. Smaller bevel angle, feed speed and higher rotational speed can effectively reduce drilling force and significantly improve drilling quality. Process parameters are optimized to achieve the low bone damage. Abstract: In order to improve the quality and reduce mechanical damage during bone drilling in surgeries, the three key parameters in drilling by the Kirschner wire are experimentally studied based on the response surface method (RSM). And through response surface analysis, a predictive model of each factor and response value is established. The experimental results found that when the beveled plane angle Φ = 10°, the rotational speed n = 1200 rpm, and the feed speed v f = 20 mm/min. Not only the drilling force is minimized, the delamination coefficient and the height of the hole exit burr are also the minimum. Therefore, the smaller bevel angle, the feed speed and the higher rotation speed can effectively reduce the drilling force, the delamination factor and the height of the hole exit burr, and significantly improve the drilling quality.