Geometrical morphology optimisation of laser drilling in B4C ceramic: From plate to hollow microsphere. Issue 2 (1st February 2018)

• Record Type: Journal Article
• Authors: Su, Lin; Chen, Ruichong; Huang, Zhangyi; Zhou, Mao; Zeng, Qiang; Shi, Qiwu; Liao, Zhijun; Lu, Tiecheng
• Is Part Of: Ceramics international. Volume 44:Issue 2(2018)
• Page Start: 1370
• Page End: 1375
• Publication Date: 2018-02-01
• Subjects: Laser drilling -- Fibre laser -- B4C -- The peak power -- The ablation time; Ceramics -- Periodicals; Céramique industrielle -- Périodiques; Ceramics; Periodicals; Electronic journals; 666
• DOI: 10.1016/j.ceramint.2017.08.206
• Languages: English
• ISSNs: 0272-8842

Abstract

Abstract: Boron carbide (B4 C) ceramic plates with 400-µm thickness and hollow microspheres were used for hole machining study with a fibre laser. The diameter, hole circularity, taper angle, and recast layer were evaluated as functions of processing parameters such as the peak power and the ablation time. Scanning electron microscope (SEM) was used to observe surface morphologies of drilled materials and the attached energy-dispersive spectrometer was used for elemental analyses of recast layers around holes. Based on the results of characterisations, holes on front side were found to have a larger diameter but a worse circularity than those on back side under different conditions. The taper angle was steady near 1.8° with the increase in laser parameter values. To obtain holes on B4 C ceramic with relatively good quality, the peak power and the ablation time should be controlled to be about 40 W and in 5–10 ms. In addition, compared with previous reports, superior holes drilled on B4 C hollow microspheres with a better circularity and smooth layer on the inner wall can be obtained.