Radial Melt Segregation During Extrusion of Partially Molten Rocks. (25th June 2019)

• Record Type: Journal Article
• Authors: Quintanilla‐Terminel, Alejandra; Dillman, Amanda M.; Pec, Matej; Diedrich, Garrett; Kohlstedt, David L.
• Is Part Of: Geochemistry, geophysics, geosystems. Volume 20:Number 6(2019)
• Page Start: 2985
• Page End: 2996
• Publication Date: 2019-06-25
• Subjects: extrusion experiment -- partially molten rock -- melt segregation -- viscous anisotropy; Geochemistry -- Periodicals; Geophysics -- Periodicals; Earth sciences -- Periodicals; 550.5
• DOI: 10.1029/2018GC008168
• Languages: English
• ISSNs: 1525-2027

Abstract

Abstract: We performed a series of extrusion experiments on partially molten samples of forsterite plus 10 vol% of an anorthite‐rich melt to investigate melt segregation in a pipe‐extrusion geometry and test the predictions of two‐phase flow theory with viscous anisotropy. The employed flow geometry has not been experimentally investigated for partially molten rocks; however, numerical solutions for a similar, pipe‐Poiseuille geometry are available. Samples were extruded from a 6‐mm diameter reservoir into a 2‐mm diameter channel under a fixed normal stress at 1350°C and 0.1 MPa. The melt distribution in the channel was subsequently mapped with optical and backscattered electron microscopy and analyzed via quantitative image analysis. Melt segregated from the center toward the outer radius of the channel. The melt fraction at the wall increased with increasing extrusion duration and with increasing shear stress. The melt fraction profiles are parabolic with the melt fraction at the wall reaching 0.17–0.66, values 2 to 16 times higher than at the channel center. Segregation of melt toward the wall of the channel is consistent with base‐state melt segregation as predicted by two‐phase flow theory with viscous anisotropy. However, melt‐rich sheets inclined at a low angle to the wall, which are anticipated from two‐phase flow theory, were not observed, indicating that the compaction length is larger than the channel diameter. The results of our experiments are a test of two‐phase flow theory that includes viscous anisotropy, an essential theoretical frame work needed for modeling large‐scale melt migration and segregation in the upper mantle. Key Points: Partially molten rocks were extruded in a Poiseuille flow geometry Melt segregates toward wall of the pipe Radial melt segregation is consistent with prediction of two‐phase flow theory with viscous anisotropy