Improvement on properties of experimental resin cements containing an iodonium salt cured under challenging polymerization conditions. Issue 10 (October 2021)

• Record Type: Journal Article
• Authors: Palialol, Alan R.; Martins, Caetano P.; Dressano, Diogo; Aguiar, Flavio H.B.; Gonçalves, Luciano S.; Marchi, Giselle M.; Pfeifer, Carmem S.; Lima, Adriano F.
• Is Part Of: Dental materials. Volume 37:Issue 10(2021)
• Page Start: 1569
• Page End: 1575
• Publication Date: 2021-10
• Subjects: Degree of conversion -- Irradiance -- Ceramic; Dentistry -- Periodicals; Dental materials -- Periodicals; 617.695
• DOI: 10.1016/j.dental.2021.08.006
• Languages: English
• ISSNs: 0109-5641

Abstract

Highlights: The addition of DPI can improve the degree of conversion under low irradiances. DPI resins had higher polymerization stress, regardless the radiant exposure. Better chemical/mechanical properties are observed at DPI resins. Abstract: Objective: The use of resin cements in clinical practice entails photopolymerization through prosthetic devices, which precludes light penetration. The objective of this study was to modify experimental resin cements (ERCs) with diphenyliodonium hexafluorophosphate (DPI) in an attempt to improve chemical and mechanical properties of materials cured with reduced irradiance and final radiant exposure. Methods: A co-monomer base containing a 1:1 mass ratio of 2.2-bis[4-(2-hydroxy-3-methacryloxypropoxy)phenyl]propane (bis-GMA) and triethyleneglycol dimethacrylate (TEGDMA) was prepared, with 1 mol% of camphorquinone and 2 mol% of ethyl 4-(dimethylamino)benzoate as initiator system. The resin was divided into 4 fractions according to the DPI concentrations (0, 0.5, 1 and 2 mol%). The challenging polymerization condition was simulated performing the light activation (12, 23 and 46 s) through a ceramic block (3 mm thick). The irradiance was assessed with a calibrated spectrometer (1320 mW/cm 2 ), resulting in three levels of radiant exposure (0.58, 1.1 and 2.2 J/cm 2 ). The polymerization kinetics was evaluated in real-time using a spectrometer (Near-IR). Water sorption and solubility was analyzed and the cohesive strength of resins obtained through the microtensile test. Polymerization stress was assessed by Bioman method. Results: Resins containing DPI had higher degree of conversion and rate of polymerization than the control (without DPI). The use of DPI reduced water sorption and solubility, and led to higher cohesive strength compared to resins without the iodonium salt. However, the stress of polymerization was higher for experimental resins with DPI. Significance: Even under remarkably reduced irradiance, cements containing a ternary initiating system with an iodonium salt can present an optimal degree of conversion and chemical/mechanical properties.