Critical heat flux and Leidenfrost temperature on Electrical Discharge Machining (EDM) - constructed hemispherical surface. (October 2021)

• Record Type: Journal Article
• Authors: Illias, S.; Hussain, S.; Rosman, N.A.; Baharudin, M.E.; Shaiful, A.I.M.; Ismail, K.A.; Ani, M.H.
• Is Part Of: Case studies in thermal engineering. Volume 27(2021)
• Publication Date: 2021-10
• Subjects: Leidenfrost temperature -- Electrical discharge machining -- Droplet -- Evaporation lifetime; Heat engineering -- Case studies -- Periodicals; 621.40205
• DOI: 10.1016/j.csite.2021.101312
• Languages: English
• ISSNs: 2214-157X

Abstract

Abstract: This paper reports a Leidenfrost temperature on hemispherical surface constructed by Electrical discharge machining or known as EDM. We focus our study on the droplet evaporation lifetime to investigate and identify the Leidenfrost temperature. Three (3) different types of materials were selected i. e such as Brass (Br), Aluminum (Al) and Copper (Cu). Meanwhile, ethanol liquid has been chosen as the test liquid. Ethanol liquid was elected due to its low boiling point of approximately 78 °C. The droplet impact velocity and droplet diameter was approximately 1.129 m/s and 3.476 mm, respectively. As a result, we finally succeeded in determining the Leidenfrost temperature for all materials mentioned above. On top of that, all the Leidenfrost temperature results, T L were close to the superheat limit temperature of ethanol liquid, T SL which is about 197.8 °C. Graphical abstract: Image 1 Highlights: The hemispherical surface was constructed using EDM technique. The evaporation process occur inside the hemispherical area which can increase the accuracy of the evaporation lifetime. The CHF and Leidenfrost temperature occurred on all heated hemispherical surfaces.