Anatomical pelvic loading of a monoblock polyethylene acetabular component. (1st May 2021)

• Record Type: Journal Article
• Authors: Young, Peter S.; Macarico, Daniela T.; Silverwood, Robert K.; Farhan-Alanie, Omer M.; Mohammed, Aslam; Periasamy, Kumar; Nicol, Alice; Meek, R. M. Dominic
• Is Part Of: Bone & joint journal. Volume 103B:Number 5(2021)
• Page Start: 872
• Page End: 880
• Publication Date: 2021-05-01
• Subjects: Hip arthroplasty -- Bone density -- Stress shielding; Bones -- Surgery -- Periodicals; Joints -- Surgery -- Periodicals; Orthopedic surgery -- Periodicals; 617.47005
• DOI: 10.1302/0301-620X.103B5.BJJ-2020-1321.R2
• Languages: English
• ISSNs: 2049-4394

Abstract

Abstract : Aims: Uncemented metal acetabular components show good osseointegration, but material stiffness causes stress shielding and retroacetabular bone loss. Cemented monoblock polyethylene components load more physiologically; however, the cement bone interface can suffer fibrous encapsulation and loosening. It was hypothesized that an uncemented titanium-sintered monoblock polyethylene component may offer the optimum combination of osseointegration and anatomical loading. Methods: A total of 38 patients were prospectively enrolled and received an uncemented monoblock polyethylene acetabular (pressfit) component. This single cohort was then retrospectively compared with previously reported randomized cohorts of cemented monoblock (cemented) and trabecular metal (trabecular) acetabular implants. The primary outcome measure was periprosthetic bone density using dual-energy x-ray absorptiometry over two years. Secondary outcomes included radiological and clinical analysis. Results: Although there were differences in the number of males and females in each group, no significant sex bias was noted (p = 0.080). Furthermore, there was no significant difference in age (p = 0.910) or baseline lumbar bone mineral density (BMD) (p = 0.998) found between any of the groups (pressfit, cemented, or trabecular). The pressfit implant initially behaved like the trabecular component with an immediate fall in BMD in the inferior and medial regions, with preserved BMD laterally, suggesting lateral rim loading. However, the pressfit component subsequently showed a reversal in BMD medially with recovery back towards baseline, and a continued rise in lateral BMD. This would suggest that the pressfit component begins to reload the medial bone over time, more akin to the cemented component. Analysis of postoperative radiographs revealed no pressfit component subsidence or movement up to two years postoperatively (100% interobserver reliability). Medial defects seen immediately postoperatively in five cases had completely resolved by two years in four patients. Conclusion: Initially, the uncemented monoblock component behaved similarly to the rigid trabecular metal component with lateral rim loading; however, over two years this changed to more closely resemble the loading pattern of a cemented polyethylene component with increasing medial pelvic loading. This indicates that the uncemented monoblock acetabular component may result in optimized fixation and preservation of retroacetabular bone stock. Cite this article: Bone Joint J 2021;103-B(5):872–880.