Geometry characteristics modeling and process optimization in coaxial laser inside wire cladding. (May 2018)

• Record Type: Journal Article
• Authors: Shi, Jianjun; Zhu, Ping; Fu, Geyan; Shi, Shihong
• Is Part Of: Optics & laser technology. Volume 101(2018)
• Page Start: 341
• Page End: 348
• Publication Date: 2018-05
• Subjects: Wire feeding -- Hollow laser -- Geometry characteristics -- Regression equation -- Energy density per unit molten pool volume; Optics -- Periodicals; Lasers -- Periodicals; Electronic journals; 621.366
• DOI: 10.1016/j.optlastec.2017.10.035
• Languages: English
• ISSNs: 0030-3992

Abstract

Highlights: The wire is always vertically fed and surrounded by special hollow laser. Models using physical theory and data statistics are established and verified. Effects of process parameters to geometry characteristics are analyzed. A wall is formed by optimized parameters and laser inside wire cladding method. Abstract: Coaxial laser inside wire cladding method is very promising as it has a very high efficiency and a consistent interaction between the laser and wire. In this paper, the energy and mass conservation law, and the regression algorithm are used together for establishing the mathematical models to study the relationship between the layer geometry characteristics (width, height and cross section area) and process parameters (laser power, scanning velocity and wire feeding speed). At the selected parameter ranges, the predicted values from the models are compared with the experimental measured results, and there is minor error existing, but they reflect the same regularity. From the models, it is seen the width of the cladding layer is proportional to both the laser power and wire feeding speed, while it firstly increases and then decreases with the increasing of the scanning velocity. The height of the cladding layer is proportional to the scanning velocity and feeding speed and inversely proportional to the laser power. The cross section area increases with the increasing of feeding speed and decreasing of scanning velocity. By using the mathematical models, the geometry characteristics of the cladding layer can be predicted by the known process parameters. Conversely, the process parameters can be calculated by the targeted geometry characteristics. The models are also suitable for multi-layer forming process. By using the optimized process parameters calculated from the models, a 45 mm-high thin-wall part is formed with smooth side surfaces.