Visualization of R410A Flow Boiling Inside Horizontal Smooth Tubes under Diabatic Conditions. Issue 15 (31st May 2021)

• Record Type: Journal Article
• Authors: Yang, Cheng-Min; Hrnjak, Pega
• Is Part Of: Heat transfer engineering. Volume 42:Issue 15(2021)
• Page Start: 1237
• Page End: 1248
• Publication Date: 2021-05-31
• Subjects: Heat -- Transmission -- Periodicals; 621.4022
• DOI: 10.1080/01457632.2020.1785691
• Languages: English
• ISSNs: 0145-7632

Abstract

Abstract: This article presents a novel approach to visualize the flow boiling in round tubes under "diabatic conditions". In the visualization test section, a 3D printed round tube is placed inside a glass tube with secondary fluid at a higher temperature flowing in the annulus between the two tubes thus providing diabatic conditions. Experimental work was conducted for evaporating R410A flow in a horizontal smooth round tube with the inner diameter of 6.3 mm. Compared to the traditional adiabatic visualization technique, the more realistic evaporative condition is simulated and the developing evaporation process is captured. New insights for the flow behavior at low vapor quality are brought by this diabatic method. The vapor plug occurs at very low vapor quality, and this is attributed to the coalescence of bubbles generated on the heated tube wall. For the intermittent flow, liquid slug triggered by Kelvin–Helmholtz instability affects the nucleation on the tube wall. It brings the fresh liquid to rewet the dry surface and activate the nucleation sites. In addition, heat flux condition affects the heat transfer mechanisms during the flow boiling, and the heat transfer through the nucleate boiling mechanism increases as the heat flux increases.