An experimental investigation on strength characteristics of fiber-reinforced clayey soil treated with lime or cement. (2nd August 2021) - Shen, Yuan-shun
Highlights: The combination effects of fiber and lime or cement on strength behaviors were given. The strength parameters of treated soils with different fiber contents were compared. The differences between peak and residual strengths of treated soils were revealed. Abstract: This paper presents an experimental investigation on the strength properties of fiber-reinforced clayey soil stabilized with lime or cement at lower content (5% by weight) cured for 28 days. A series of consolidated undrained (CU) triaxial compression tests and unconfined compressive (UC) strength tests were conducted on compacted untreated, lime-treated and cement-treated clayey soil specimens reinforced with different polyester fiber content (i.e., 0%, 0.05%, 0.1%, 0.2% by weight) to evaluate the effect of fiber content on the strength behavior of tested soil. Test results indicated that the addition of lime or cement gave a significant increase in strength and strength parameters at a certain fiber content, where the improvement effect of cement is better than that of lime. Strain-softening curves were obtained for lime-treated or cement-treated fiber-reinforced specimens compared with the strain-hardening for fiber-reinforced ones. The residual strength is about 75% on average the peak strength for fiber and lime-treated specimens compared to about 50% decrease of peak strength for fiber and cement-treated specimens. The stress and strain curve for the specimen with higher fiber content lies above on that with lower fiber content. Fiber-reinforced plain soil showed a ductile failure mode compared with brittle failure mode for lime or cement-treated specimen. The values of undrained shear strength, unconfined compressive strength, cohesion and internal friction angle of plain soil and lime-treated soil followed the same increase trend when the polyester fiber content increased from 0% to 0.2%. While for lime-treated soil specimens, peak values can be observed when the fiber content was 0.1%. It is recommended to use the optimum fiber content to achieve a better improvement effect in the engineering applications.