Comparative Analysis of Bulge Deformation between 2D and 3D Finite Element Models. (25th February 2014)

• Record Type: Journal Article
• Authors: Qin, Qin; Shang, Shu; Wu, Diping; Zang, Yong
• Other Names: Wu Jia-Jang Academic Editor.
• Is Part Of: Advances in mechanical engineering. Volume 2014(2014)
• Publication Date: 2014-02-25
• Subjects: Mechanical engineering -- Periodicals; 621.05
• DOI: 10.1155/2014/942719
• Languages: English
• ISSNs: 1687-8132

Abstract

Abstract : Bulge deformation of the slab is one of the main factors that affect slab quality in continuous casting. This paper describes an investigation into bulge deformation using ABAQUS to model the solidification process. A three-dimensional finite element analysis model of the slab solidification process has been first established because the bulge deformation is closely related to slab temperature distributions. Based on slab temperature distributions, a three-dimensional thermomechanical coupling model including the slab, the rollers, and the dynamic contact between them has also been constructed and applied to a case study. The thermomechanical coupling model produces outputs such as the rules of bulge deformation. Moreover, the three-dimensional model has been compared with a two-dimensional model to discuss the differences between the two models in calculating the bulge deformation. The results show that the platform zone exists in the wide side of the slab and the bulge deformation is affected strongly by the ratio of width-to-thickness. The indications are also that the difference of the bulge deformation for the two modeling ways is little when the ratio of width-to-thickness is larger than six.