Interfacial microstructure and reaction mechanism with various weld fillers on laser welding-brazing of Al/Cu lap joint. (July 2021)

• Record Type: Journal Article
• Authors: Lei, Zhenglong; Zhang, Xinrui; Liu, Jinge; Li, Peng
• Is Part Of: Journal of manufacturing processes. Volume 67(2021)
• Page Start: 226
• Page End: 240
• Publication Date: 2021-07
• Subjects: Copper alloy -- Aluminium alloy -- Laser welding-brazing -- Metallurgical bonding -- Interfacial reaction; Production management -- Data processing -- Periodicals; Manufacturing processes -- Periodicals; Procestechnologie; Productietechniek; Production -- Gestion -- Informatique -- Périodiques; Fabrication -- Périodiques; Manufacturing processes; Production management -- Data processing; Periodicals; 670.5
• DOI: 10.1016/j.jmapro.2021.04.065
• Languages: English
• ISSNs: 1526-6125

Abstract

Abstract: The influence of pure Al, Al-Si and Zn-Al weld fillers on microstructure and mechanical properties was investigated during lap laser welding-brazing of Al to Cu. Al4.2 Cu3.2 Zn0.7 IMC layer and plate-like Al2 Cu phase were observed at Al/Cu interface with pure Al and Al-Si weld fillers. Microcrack was easy to generate in Al2 Cu phase decreasing the joint strength. When the Zn-Al weld filler was adopted, the formation of Al2 Cu brittle phase was limited by low Al content and the CuZn and CuZn5 IMC layers were observed at Al/Cu interface. According to the chemical potential, the diffusivity of Cu atoms in Zn-Al weld filler was much lower than that of pure Al and Al-Si weld fillers, which prevented from the formation of coppery phases near the Al/Cu interface. Si atoms tended to concentrate at Al/Cu interface. It played a role in obstructing the diffusion of Cu atoms, enhancing the Al/Cu joint strength to some extent. According to nanoindentation result, the mechanical property of the formed phases (CuZn and CuZn5 ) in the case of Zn-Al weld filler was better than that formed with pure Al and Al-Si weld fillers such as Al2 Cu and Al4.2 Cu3.2 Zn0.7 . The highest tensile strength was 148 MPa with Zn-Al weld filler.