UMG silicon for solar PV: From defects detection to PV module degradation. (15th May 2021)

• Record Type: Journal Article
• Authors: Forniés, Eduardo; del Cañizo, Carlos; Méndez, Laura; Souto, Alejandro; Pérez Vázquez, Antonio; Garrain, Daniel
• Is Part Of: Solar energy. Volume 220(2021)
• Page Start: 354
• Page End: 362
• Publication Date: 2021-05-15
• Subjects: Degradation -- UMG -- Lifetime -- Carbon footprint -- Silicon purification -- Defect detection; Solar energy -- Periodicals; Solar engines -- Periodicals; 621.47
• DOI: 10.1016/j.solener.2021.03.076
• Languages: English
• ISSNs: 0038-092X

Abstract

Highlights: Silicon purification process through metallurgical route. Chemical analysis of wafers and its relationship with lifetime. Relationship of lifetime and solar cell efficiency. Degradation of UMG-Si modules and polysilicon modules is equivalent. Life cycle assessment of UMG-Si shows a much lower carbon footprint than polysilicon. Abstract: Upgraded metallurgical grade silicon (UMG-Si) for photovoltaic (PV) solar applications has been manufactured through the metallurgical route by means of the process developed by Ferrosolar. In an ambitious mass production test, performed in commercial solar cells and modules production lines, the silicon was proven to be appropriate for photovoltaics applications (Forniés et al., 2019 Mass production test of solar cells and modules made of 100% umg silicon. 20.76% record efficiency. Energies 12), reaching, in a conventional production line, up to 20.76% of solar cell efficiency with multicrystalline cells made of 100% UMG silicon. In this paper we present more results from the mentioned massive test. Defect engineering is being applied to improve the bulk lifetime of the UMG wafers and to guide in the identification of the limiting defects in the material. Moreover, the modules produced with 100% UMG silicon solar cells were installed together with the modules produced in the same production line with polysilicon material to assess the degradation of the UMG silicon when compared to polysilicon. After 24 months of outdoor PV generation, the degradation, in terms of Performance Ratio at 25 °C ( 25 PR) diminution, has been the same for both types of modules. Additionally, a Life Cycle Assessment (LCA) has been performed for this UMG silicon and state-of-the-art Siemens polysilicon to compare the environmental impact of both silicon feedstocks. The results presented in this paper; chemical analysis of wafers, defect engineering, low degradation, average efficiency and environmental assessment, lead to a complete study of UMG silicon, confirming its potential to be used as raw material for PV applications.