Influence of the contact angle on the wettability of horizontal-tube falling films in the droplet and jet flow modes. (June 2018)

• Record Type: Journal Article
• Authors: Fernandez de Arroiabe, Peru; Martinez-Urrutia, Asier; Peña, Xabier; Martinez-Agirre, Manex; Bou-Ali, M. Mounir
• Is Part Of: International journal of refrigeration. Volume 90(2018)
• Page Start: 12
• Page End: 21
• Publication Date: 2018-06
• Subjects: Absorption technologies -- Water-lithium bromide -- Falling film -- Contact angle -- Wettability -- CFD; Technologies d'absorption -- Bromure de lithium-eau -- Film tombant -- Angle de contact -- Mouillabilité -- Mécanique numérique des fluides (CFD); Refrigeration and refrigerating machinery -- Periodicals; 621.56
• DOI: 10.1016/j.ijrefrig.2018.04.003
• Languages: English
• ISSNs: 0140-7007

Abstract

Highlights: The influence of contact angle on absorbers is numerically analysed. 3D models are needed to analyse the wetted area in cases of incomplete wetting. Flow hydrodynamics, flow mode and wetted area may change with contact angle. The contact angle should be considered in LiBr-H2O absorbers analysis and design. Abstract: Wettability has a key impact on the performance of LiBr-H2 O horizontal-tube falling film absorbers working under typical operating conditions. Therefore, it is necessary to study the influence of the wettability properties on the film hydrodynamics and wetted area. This work analyses the influence of the contact angle (0–120°) on the transient film hydrodynamics and the wetted area in the droplet and jet flow modes (7 ≤ Re ≤ 53). The comparison between two-dimensional and three-dimensional models evidences that three-dimensional models are needed for incomplete wetting conditions. The influence of the contact angle on both the film hydrodynamics and wetted area is demonstrated using 3D unsteady CFD model. Furthermore, the results indicate that each Reynolds number has a maximum contact angle to wet the whole tube steadily. When the value of the contact angle is lower than this maximum value, the contact angle has not influence on the wetting ratio. In contrast, at higher values, the wetting ratio decreases as the contact angle increases.