Capacitor static voltage balance based on auxiliary‐power supply pulse width control for MMC. Issue 11 (1st September 2018)

• Record Type: Journal Article
• Authors: Luo, Longfei; Zhang, Yanbin; Jia, Lixin; Yang, Ningning; Yang, Lixia; Zhang, Huihui
• Is Part Of: IET power electronics. Volume 11:Issue 11(2018)
• Page Start: 1796
• Page End: 1803
• Publication Date: 2018-09-01
• Subjects: closed loop systems -- voltage control -- HVDC power convertors -- power capacitors -- HVDC power transmission -- voltage‐source convertors -- power transmission control -- logic gates; auxiliary‐power supply pulse width control -- MMC -- modular multilevel converter -- high‐voltage direct current transmission systems -- capacitor static voltage imbalance -- capacitor static voltage balance method -- control signal -- modulation signal -- voltage closed‐loop control -- carrier signal -- capacitor voltage -- SM -- control strategy -- HVDC system -- AND gate circuit -- APS MOS driving circuits -- submodule APS; Power electronics -- Periodicals; 621.31705
• DOI: 10.1049/iet-pel.2017.0672
• Languages: English
• ISSNs: 1755-4535

Abstract

Abstract : As one of the most potential converter topologies, modular multilevel converter (MMC) is widely used in high‐voltage direct current (HVDC) transmission systems. The capacitor static voltage imbalance during HVDC system start‐up stage has become a key issue. This study presents a new capacitor static voltage balance method based on auxiliary‐power supply (APS) pulse width control for MMC. The control signal of APS can be generated by comparing the modulation signal for voltage closed‐loop control with the carrier signal with fixed frequency. An AND gate circuit is used to improve the APS Metal oxide semiconductor (MOS) driving circuits. Based on these circuits, the input current of APS can be regulated, and the capacitor voltage can be controlled. Since only the inherent sub‐module (SM) APS is needed in this method, it has low hardware costs. The control strategy in this method is simple, and it has no restrictions on the SM number. This determines that the presented method has a wider range of application. Furthermore, the value of equalising resistor is increased, and the losses of SM and MMC are reduced in this method. Experimental results from the laboratory prototype verify the effectiveness of the presented method.