3D imaging techniques for characterising microcracks in cement-based materials. (February 2021)

• Record Type: Journal Article
• Authors: Mac, M.J.; Yio, M.H.N.; Desbois, G.; Casanova, I.; Wong, H.S.; Buenfeld, N.R.
• Is Part Of: Cement and concrete research. Volume 140(2021)
• Publication Date: 2021-02
• Subjects: Microstructure (B) -- Microcracking (B) -- Image analysis (B) -- Durability (C) -- Concrete (E) -- 3D imaging; Cement -- Periodicals; Cement -- Research -- Periodicals; Concrete -- Periodicals; Concrete -- Research -- Periodicals; Ciment -- Périodiques; Béton -- Périodiques; Cement; Concrete; Periodicals; 620.135
• DOI: 10.1016/j.cemconres.2020.106309
• Languages: English
• ISSNs: 0008-8846

Abstract

Abstract: Concrete inherently contains pores and microcracks that can adversely impact its mechanical properties and long-term durability. However, characterising microcracks is difficult due to their complex, multiscale and three-dimensional (3D) nature. This paper presents an evaluation of 3D imaging techniques for characterising microcracks induced by different mechanisms. Seven cement pastes, mortars and concretes subjected to drying shrinkage, autogenous shrinkage and freeze-thaw cycles were investigated using focused ion beam nanotomography (FIB-nt), broad ion beam serial section tomography (BIB-SST), laser scanning confocal microscopy (LSCM) combined with serial sectioning and X-ray microtomography (μCT). The study shows that the characteristics of microcracks vary significantly depending on exposure conditions. Yet there is no single technique that can capture the entire size range of microcracks from sub to tens of μm within a sufficiently representative sampling volume. The achievable image volume and resolution, and the advantages and disadvantages of each technique are compared and discussed.