Multiobjective optimization for improving machinability of Ti-6Al-4V using RSM and advanced algorithms. Issue 1 (10th May 2018)

• Record Type: Journal Article
• Authors: Sahu, Neelesh Kumar; Andhare, Atul B.
• Is Part Of: Journal of computational design and engineering. Volume 6:Issue 1(2019)
• Page Start: 1
• Page End: 12
• Publication Date: 2018-05-10
• Subjects: Titanium alloys -- Response surface methodology -- Teaching learning based optimization -- 'JAYA' -- Cutting force -- Surface roughness; Engineering -- Data processing -- Periodicals; Computer-aided design -- Periodicals; Computer-aided design; Engineering -- Data processing; Electronic journals; Electronic journals; Periodicals; 620.0042
• DOI: 10.1016/j.jcde.2018.04.004
• Languages: English
• ISSNs: 2288-4300

Abstract

Graphical abstract: Abstract: This paper explores use of Teaching Learning Based Optimization (TLBO), 'JAYA' (Sanskrit word means Victory) and Genetic Algorithm (GA) for the combined minimization of roughness of machined surface and forces generated in cutting in turning of Ti-6Al-4V. Experimentation was carried out with Response Surface Methodology (RSM) and the Central Composite Design (CCD). Speed of cutting (m/min), feed rate (mm/min) and depth of cut (mm) were the design variables for optimization. Two responses (roughness of machined surface and force of cutting) were independently minimized. RSM was useful in finding empirical relations and the effect of each parameter and their interactions on the responses considered. Analysis of variance (ANOVA) was used to find out the effective and non-effective factors and correctness of the models. Later on, a multi-objective optimization function was developed for minimizing both – roughness in machined surface and force generated in cutting using weights method and the correctness of weights were confirmed by Analytical Hierarchy Process (AHP). After formulating the combined objective function, TLBO, 'JAYA' and GA methods were used for further parameter optimization of the turning process. Performance of TLBO and 'JAYA' algorithm was compared with that of Genetic Algorithm (GA). It is found that TLBO and 'JAYA' performed better than GA in the combined minimization of roughness and forces in while turning Ti-6Al-4V. It is also found from the results that higher cutting speed (171.4 m/min) and lower feed rate (55.6 mm/min) can produce better surface roughness and minimum cutting forces in machining of Ti-6Al-4V.