Micro‐cone textures for improved light in‐coupling and retroreflection‐inspired light trapping at the front surface of solar modules. (2nd May 2019)

• Record Type: Journal Article
• Authors: Dottermusch, Stephan; Schmager, Raphael; Klampaftis, Efthymios; Paetel, Stefan; Kiowski, Oliver; Ding, Kaining; Richards, Bryce S.; Paetzold, Ulrich W.
• Is Part Of: Progress in photovoltaics. Volume 27:Number 7(2019)
• Page Start: 593
• Page End: 602
• Publication Date: 2019-05-02
• Subjects: antireflection -- direct laser writing -- light trapping -- photovoltaics -- solar cells; Solar cells -- Periodicals; Photovoltaic cells -- Periodicals; Solar power plants -- Periodicals; 621.31245
• DOI: 10.1002/pip.3133
• Languages: English
• ISSNs: 1062-7995

Abstract

Abstract: Micron‐scale textures at the front surface of solar modules have been reported to improve the current generation by both enhancing light in‐coupling as well as by reducing light out‐coupling via back‐reflection, similar to the retroreflective effect. Whereas the general working principle and advantages of these textures have been described previously, here, the interplay of the reflection properties of different substrates with the enhancement effects is analyzed for textures of conical geometry. The study takes into consideration the incident light of arbitrary angle of incidence as well as the overall energy yield. Supported by optical simulations, periodic micro‐cone textures were optimized and prototyped based on direct laser writing and a scalable replication process. Micron‐scale textures with cones of various aspect ratios were examined on mono‐crystalline silicon (c‐Si) solar cells; an optimum aspect ratio of 0.73 was identified. This moderate aspect ratio is suitable for large‐scale replication, while showing near‐zero surface reflection and excellent light trapping. An increase in energy yield of up to 8% was calculated for the case of micro‐cone textures at the front surface of commercial alkaline‐etched c‐Si solar cells. Moreover, the excellent optical properties of the micro‐cone textures were highlighted by improving the power conversion efficiency (PCE) of a Cu(In, Ga)Se2 (CIGS) thin‐film solar cells from 20.2% to 20.9%. A comparable PCE improvement has been achieved by conventional MgF2 antireflection coatings, but the angular stability and in turn the energy yield of the micro‐cone textures is much higher. Abstract : Micron‐scale textures applied to the front surface of solar modules enhance the transmission to the underlying solar cells and trap light reflected from the solar cells. A systematic experimental study of conical micro‐textures is performed, focusing on the aspect ratio. The interaction between the texture and solar cell is investigated in detail, and the angle‐stable performance enhancement on different photovoltaic devices is demonstrated.