Effect of nano CuO addition on the tribo‐mechanical behavior of alumina ceramics in non‐conformal contact. Issue 1 (16th September 2020)

• Record Type: Journal Article
• Authors: Haldar, Partha; Bhattacharya, Tapas Kumar; Modak, Nipu
• Is Part Of: International journal of applied ceramic technology. Volume 18:Issue 1(2021)
• Page Start: 110
• Page End: 118
• Publication Date: 2020-09-16
• Subjects: Al2O3 -- mechanical properties -- sintering -- wear resistance; Ceramics -- Periodicals; Ceramics -- Technological innovations -- Periodicals; 620.1405
• DOI: 10.1111/ijac.13620
• Languages: English
• ISSNs: 1546-542X

Abstract

Abstract: Sintering of alumina from 1500°C to 1650°C and tribo‐mechanical properties at room temperature had been investigated using nano CuO as a sintering aid. Bulk density gradually increases with sintering temperature from 1500°C to 1600°C and is optimized at 1600°C, beyond this, bulk density does not significantly increase at 1650°C. The addition of 2 wt% CuO showed the best result on densification. Densification of about 97.74% was attained at 1600°C with the incorporation of 2 wt% CuO. Nano CuO at grain boundaries forms CuAl2 O4 liquid which modifies the morphology of the grain and improves mechanical properties. The formation of self‐lubricating tribo‐film on the wear track results in a low coefficient of friction <0.2 and reduces specific wear rate. 4 wt% CuO addition increases contact tensile stress ( σ max ) by 51.2% and high Hertzian contact pressure ( P max ≈1.51 GPa) causes plastic deformation of wear track. The re‐solidified strengthening bond phase on the wear track simultaneously increases in friction coefficient and wear resistance with CuO addition. The optimizing effect of CuO addition shows that 2 wt% significantly decreases wear rate, and increases hardness and fracture toughness.