Coefficient of friction and wear rate of paper-based composite friction material against 65Mn steel. (March 2021)

• Record Type: Journal Article
• Authors: Koranteng, Kingsford; Li, Heyan; Ma, Biao; Ma, Chengnan
• Is Part Of: Proceedings of the Institution of Mechanical Engineers. Volume 235:Number 3(2021)
• Page Start: 544
• Page End: 550
• Publication Date: 2021-03
• Subjects: Paper-based -- friction coefficient -- 65Mn -- pin-on-disc -- wear rate; Tribology -- Periodicals; 621.89
• DOI: 10.1177/1350650120972292
• Languages: English
• ISSNs: 1350-6501

Abstract

Studies have shown that reinforced paper-based friction material with 600 µm carbon fiber length possesses a high dynamic friction coefficient but is subjected to abrasive wear during sliding contact. This work is devoted to further investigate the effect of operating variables on this friction material subjected to high operating conditions. A pin-on-disc test was carried out to determine the tribological behavior of this friction material sliding against 65Mn steel. The friction and wear rate results from measurements were discussed. The highest friction value of about 0.3 was obtained by varying the applied load at 120 N while the lowest friction value close to 0.02 was obtained when the sliding speed was 0.026 m/s. Increasing the sliding speed above 0.30 m/s caused constant temperature (175 °C) to fluctuate due to high friction heat generation on the sliding surface. The highest wear rate was 1.42 × 10 −15 m 3 /Nm by varying the sliding speed at 1.31 m/s. In contrast, the lowest wear rate was 2.1 × 10 −16 m 3 /Nm when the temperature was at 400 °C.