Effect of temperature on selenium removal from wastewater by UASB reactors. (1st May 2016)

• Record Type: Journal Article
• Authors: Dessì, Paolo; Jain, Rohan; Singh, Satyendra; Seder-Colomina, Marina; van Hullebusch, Eric D.; Rene, Eldon R.; Ahammad, Shaikh Ziauddin; Carucci, Alessandra; Lens, Piet N.L.
• Is Part Of: Water research. Volume 94(2016)
• Page Start: 146
• Page End: 154
• Publication Date: 2016-05-01
• Subjects: Selenate -- Thermophilic -- Nitrate -- Selenium nanoparticles -- UASB; Water -- Pollution -- Research -- Periodicals; 363.7394
• DOI: 10.1016/j.watres.2016.02.007
• Languages: English
• ISSNs: 0043-1354

Abstract

Abstract: The effect of temperature on selenium (Se) removal by upflow anaerobic sludge blanket (UASB) reactors treating selenate and nitrate containing wastewater was investigated by comparing the performance of a thermophilic (55 °C) versus a mesophilic (30 °C) UASB reactor. When only selenate (50 μM) was fed to the UASB reactors (pH 7.3; hydraulic retention time 8 h) with excess electron donor (lactate at 1.38 mM corresponding to an organic loading rate of 0.5 g COD L −1 d −1 ), the thermophilic UASB reactor achieved a higher total Se removal efficiency (94.4 ± 2.4%) than the mesophilic UASB reactor (82.0 ± 3.8%). When 5000 μM nitrate was further added to the influent, total Se removal was again better under thermophilic (70.1 ± 6.6%) when compared to mesophilic (43.6 ± 8.8%) conditions. The higher total effluent Se concentration in the mesophilic UASB reactor was due to the higher concentrations of biogenic elemental Se nanoparticles (BioSeNPs). The shape of the BioSeNPs observed in both UASB reactors was different: nanospheres and nanorods, respectively, in the mesophilic and thermophilic UASB reactors. Microbial community analysis showed the presence of selenate respirers as well as denitrifying microorganisms. Graphical abstract: Highlights: UASB reactor at 55 °C achieves a 10–15% higher total Se removal efficiency than at 30 °C. BioSeNPs produced at 55 °C are nanorods, whereas nanospheres at 30 °C. Adding NO3 – to the feed decreases the Se removal efficiency.