H-mode pedestal improvements with neon injection in DIII-D. (10th April 2020)

• Record Type: Journal Article
• Authors: Lan, H.; Osborne, T.H.; Groebner, R.J.; Snyder, P.B.; Xu, G.S.; Grierson, B.A.; Victor, B.S.; Leonard, A.W.; Wang, H.Q.
• Other Names: collab.
• Is Part Of: Nuclear fusion. Volume 60:Number 5(2020)
• Publication Date: 2020-04-10
• Subjects: DIII-D -- pedestal -- H-mode -- neon; Nuclear fusion -- Periodicals; 621.48405
• DOI: 10.1088/1741-4326/ab7c2b
• Languages: English
• ISSNs: 0029-5515

Abstract

Abstract: Improvements in the H-mode pedestal pressure and global energy confinement were observed on DIII-D with both 3 and 6 MW of neutral beam (NBI) heating with neon injection. The pedestal pressure increased, primarily associated with a significant increase in the pedestal density with a relatively smaller decrease in the pedestal temperature. At the same neon injection rate, a rapid decrease in edge localized mode (ELM) frequency and ∼35% increase in plasma stored energy were observed in the 3 MW discharge, while in the 6 MW discharge, the ELM frequency was gradually decreased and the plasma stored energy gradually increased by up to 20%. The measured pedestal widths from both 3 and 6 MW discharges matched the EPED1.0 width scaling, Δ ψ N = 0.089 β p, p e d 1 / 2, within 20% deviations before and after neon injection. The peeling-ballooning mode (PBM) stability analysis showed that after neon injection, the ballooning stability boundary was increased, while the peeling stability boundary only dropped once the neon level was relatively high. The ballooning stability boundary increase with neon injection is consistent with increase of the ion diamagnetic stabilization (i.e. including the contribution from carbon, neon as well as deuterium ions) which is used in the criterion to determine when the calculated linear growth rates of PBM are unstable. Consequently, the new ELITE computed PBM boundaries were more consistent with the operating points than when only deuterium was included. This in turn indicates that the impurity may help to improve pedestal pressure through affecting ion diamagnetic frequency in the pedestal region, which could positively lead to the ballooning stability boundary extension.