Optimization of the fractional collection efficiencies for electrostatic precipitators used in biomass-fired boilers. (October 2020)

• Record Type: Journal Article
• Authors: Oischinger, Jürgen; Steiner, Michael; Meiller, Martin; Hebauer, Michael; Beer, Stefan; Daschner, Robert; Hornung, Andreas; Kramb, Jan
• Is Part Of: Biomass and bioenergy. Volume 141(2020)
• Publication Date: 2020-10
• Subjects: Electrostatic precipitator -- Fractional collection efficiency -- Biomass-fired boiler -- Wood chips -- Particulate matter -- Fine dust; ESPs Electrostatic precipitators -- FCE fractional collection efficiency -- SMPS Scanning Mobility Particle Sizer -- DLPI Dekati® Low Pressure Impactor -- TS test series -- OTH Ostbayerische Technische Hochschule; Biomass energy -- Periodicals; Biomass -- Periodicals; Energy-Generating Resources -- Periodicals; Bioénergie -- Périodiques; 333.9539
• DOI: 10.1016/j.biombioe.2020.105703
• Languages: English
• ISSNs: 0961-9534

Abstract

Abstract: Electrostatic precipitators (ESPs) are commonly used for dust removal in flue gases from biomass-fired boilers. ESPs are able to precipitate the PM10 fraction (Nussbaumer, 2010) [1]. According to literature, ESPs have a reduced fractional collection efficiency (FCE) in the range of 0.2–2 μm with a minimum at about 0.7 μm (Kaltschmitt et al., 2016; Fritz and Kern, 1992; Lützke and Wilkes, 1981) [2–4]. In the research project "Optimization of the fractional collection efficiencies for electrostatic precipitators used in biomass-fired boilers (FRESBI)" the FCEs for three commercial available ESPs (OekoTube Inside – Co. Oekosolve, Filterbox S – Co. Schraeder, Filterbox 2K – Co. Schraeder) were examined. The particle size distributions in the flue gas were measured using a Scanning Mobility Particle Sizer (SMPS) and a 13 stage Dekati® Low Pressure Impactor (DLPI). The combination of both measuring methods was a successful setup with various symbiotic effects. Additionally a mathematic model for the prediction of the FCEs of tubular ESPs was developed und successfully validated. For two ESPs (OekoTube Inside and Filterbox S) optimization measures were implemented, tested and evaluated. The applied measures focused on the optimization of the electrical field strength, hence increasing the performance of the ESPs. For the Filterbox S an increased FCE was achieved. Highlights: PM concentrations in the raw gas were reduced via ESPs to values of 9–11 mg/m −3 Fractional collection efficiencies measured with SMPS have a minimum at 0.1–0.3 μm. Potassium is a dominant element in the PM1 -emissions of the deployed woodchips. For the Filterbox S the FCE was improved by a higher electrical field strength.