The influence of cutting parameters on micro-topography of frequency features extracted from the machined KH2PO4 surfaces. (December 2020)

• Record Type: Journal Article
• Authors: Pang, Qilong; Kuang, Liangjie; Xu, Youlin
• Is Part Of: Proceedings of the Institution of Mechanical Engineers. Volume 234:Number 14(2020)
• Page Start: 1762
• Page End: 1770
• Publication Date: 2020-12
• Subjects: Continuous wavelet transform -- power spectral density -- frequency -- cutting parameter -- surface topography; Mechanical engineering -- Periodicals; Engineering -- Management -- Periodicals; Manufacturing processes -- Periodicals; 629.8
• DOI: 10.1177/0954405420927561
• Languages: English
• ISSNs: 0954-4054

Abstract

Using reasonable cutting parameters of machining process is an effective and convenient means of improving the topography of the machined surfaces. In this study, the methods to find optimised cutting parameters can be obtained by studying the relationship between the cutting parameters and the micro-topography of frequency features in the machined KH2 PO4 surfaces. Using the power spectral density and continuous wavelet transform methods, the 2D micro-topographies of frequencies corresponding to different cutting parameters are extracted from the machined KH2 PO4 surfaces. The results for the extracted micro-topography are used to analyse the influence of cutting parameters on the spatial frequency feature which consists of the wavelength and amplitude. The middle-frequency feature reflects the variations of depth of cut and spindle speed, and the amplitude of it is directly proportional to depth of cut and spindle speed. The low-frequency feature reflects the variations of the feed rate and decreases to a smaller value when the feed rate increases. The high-frequency feature is mainly affected by the material properties and the vibrations that occur during processing. Comparing the micro-topography of frequencies under different cutting parameters, the depth of cut (3 μm), the spindle speed (400 r/min) and the feed rate (8 μm/r) are the optimised cutting parameters for the machine tools used in this article. In the process of reconstructing the arbitrary frequency topography, the continuous wavelet transform method can compensate for the deficiencies of the power spectral density method for extracting frequencies.