Self assembled monolayer of silica nanoparticles with improved order by drop casting. Issue 31 (13th May 2020)

• Record Type: Journal Article
• Authors: Qdemat, Asma; Kentzinger, Emmanuel; Buitenhuis, Johan; Rücker, Ulrich; Ganeva, Marina; Brückel, Thomas
• Is Part Of: RSC advances. Volume 10:Issue 31(2020)
• Page Start: 18339
• Page End: 18347
• Publication Date: 2020-05-13
• Subjects: Chemistry -- Periodicals; 540.5
• DOI: 10.1039/d0ra00936a
• Languages: English
• ISSNs: 2046-2069

Abstract

Abstract : Grazing incidence small angle scattering and electron microscopy have been used to show a large area monolayers with improved order. Abstract : This paper reports on the formation of large area, self assembled, highly ordered monolayers of stearyl alcohol grafted silica nanospheres of ≈50 nm diameter on a silicon substrate based on the drop-casting method. Our novel approach to achieve improved order uses stearyl alcohol as an assistant by adding it to the colloidal NanoParticle (NP) dispersion from which the monolayers are formed. Additionally, a heat treatment step is added, to melt the stearyl alcohol in the monolayer and thereby give the particles more time to further self-assemble, leading to additional improvement in the monolayer quality. The formation of the monolayers is significantly affected by the concentration of the NPs and the stearyl alcohol, the volume of the drop as well as the time of the heat treatment. A high surface coverage and uniform monolayer film of SiO2 NPs is achieved by appropriate control of the above-mentioned preparation parameters. Structural characterization of the obtained SiO2 NP monolayer was done locally by Scanning Electron Microscopy (SEM), and globally by X-ray reflectivity (XRR) and grazing incidence small-angle X-ray scattering (GISAXS), where the data was reproduced by simulation within the Distorted Wave Born Approximation (DWBA). In conclusion, our modified drop-casting method is a simple, inexpensive method, which provides highly ordered self-assembled monolayers of silica particles, if combined with a compatible additive and a heat treatment step. This method might be more general and also applicable to different particles after finding an appropriate additive.