The effect of the horizontal metallic drive on reference dosimetry in the SNC 3D scanner water tank. Issue 4 (1st April 2020)

• Record Type: Journal Article
• Authors: Aftab, Sadia; Barnes, Michael P.; Doebrich, Marcus; Lehmann, Joerg
• Is Part Of: Journal of applied clinical medical physics. Volume 21:Issue 4(2020)
• Page Start: 95
• Page End: 101
• Publication Date: 2020-04-01
• Subjects: 3D scanner -- backscatter -- reference dosimetry -- water tank; Medical physics -- Periodicals; Clinical medicine -- Periodicals; Health Physics; Clinical Medicine; Electronic journals; Periodicals; Periodicals; Fulltext; Internet Resources; 610.153
• DOI: 10.1002/acm2.12858
• Languages: English
• ISSNs: 1526-9914

Abstract

Abstract: Accurate quantification of absorbed radiation dose is important for safe and effective delivery of radiation therapy. An important aspect to this is reference dosimetry, which is performed under reference conditions specified by international codes of practice. Such measurements are usually performed in a water phantom. In the Sun Nuclear Corporation (SNC) three‐dimensional (3D) scanner water tank system the detector holder is fixed to a horizontal metallic drive rail (MDR) which is in close proximity to the active volume of the detector. In this project, the dosimetric effects of the MDR on reference dosimetry were investigated for MV photons, MeV electrons, and kV photons by comparing reference dosimetry measurements in the SNC 3D scanner against similar measurements in a Standard Imaging (SI) one‐dimensional (1D) tank and against measurements in the SNC 3D scanner with an additional, custom‐made spacer placed beneath the chamber holder to increase the chamber ‐ MDR separation. A second experiment investigated the difference in chamber reading dependent on chamber to MDR separation by fixing the chamber in the tank independently of the MDR and successively moving the MDR vertically to alter the separation. The results showed that measurements in the SNC 3D scanner agree with both SI 1D tank and SNC 3D scanner with spacer to within ±0.3% for MV photons, ±0.1% for electrons and ±1.2% for kV photons within the calculated setup uncertainty. The second experiment showed that the contribution of backscatter from the MDR was significant if the distance between MDR and chamber was reduced below the chamber's designed position in the SNC 3D scanner. The exception was for kV photons where the contribution of backscatter from the MDR was measured to be 0.5% at the designed distance. Further investigation would be useful for kV photons, where the experiment showed relatively large measurement uncertainties.